BM 2610019163 10-11:BM 2610019163 09-11.qxp 10/13/11 7:55 AM Page 2
Read and understand all
WARNING
instructions. Failure to follow
all instructions listed below and in your tile saw
manual may result in serious personal injury.
Fully assemble and tighten all the fasteners
required for this stand. Also remember to
occasionally check the stand and make
sure it is still tight. A loose stand is unstable
and may shift in use and cause serious injury.
Turn tool switch off, disconnect tool power
and empty water from tray before mounting
on stand and removing from stand.
Unintended startup during assembly can
cause inury.
You have purchased a Bosch GTA10 Folding
Tile Saw Stand. The stand is designed for use
exclusively with Bosch TC10 Wet Tile and
Stone Saw. Designed for job site use, this unit
sets up and folds quickly.
If any parts are missing, do
WARNING
not attempt to assemble the
stand until the missing parts are obtained
and are installed correctly.
Safety Instructions
Before operating tile saw, ensure tile saw
base lines up evenly within the stand
retaining walls at each corner. Serious
injury could occur if tool is unstable and tips.
Before operating make sure the entire unit
is placed on a solid, flat, level surface.
Serious injury could occur if tool is unstable
and tips.
Never stand on tool or its stand or use as
ladder or scaffolding. Serious injury could
occur if the tool is tipped or the cutting tool is
accidentally contacted. Do not store materials
on or near the tool such that it is necessary to
stand on the tool or its stand to reach them.
Use only Bosch replacement parts. Any
others may create a hazard.
Pre-Assembly
Sort out and account for all parts to make sure
that you have all necessary materials to
assemble your stand. Do not discard packing
material until all parts are accounted for.
Item
A
B
C
D
E
-2-
BEFORE YOU ASSEMBLE THIS
TILE SAw STAND:
GTA10 TILE SAw STAND
PAckAGE cONTENTS:
Qty.
Part Description
(1)
Stand
(4)
Stand Leg
(4)
Bolt
(8)
Washer
(4)
Lock Nut