Bosch GTA10 Instrucciones De Funcionamiento página 3

BM 2610019163 10-11:BM 2610019163 09-11.qxp 10/13/11 7:55 AM Page 3
ASSEMBLING THE STAND
For your own safety, never
WARNING
mount tool on stand until all
assembly steps are complete and until you
have read and understood the entire
owner's manual.
1. Slide the legs B into the stand (Fig. 1).
Note: You can select from two height options
depending on which hole you select. For best
balance, select the same hole on all four legs.
2. Align the hole in the leg with the hole in the
stand.
3. Install a bolt c and washer D through each
leg.
4. Slide the second washer over the open end.
Then use a socket and a wrench to tighten
the nuts E securely.
Make sure leg extension is fully assembled
to stand.
Place stand on solid, flat, level surface.
Read and follow transporting and mounting
instructions in Bosch Tc10 manual.
1. Unfold stand to open position.
2. Place the TC10 Wet Tile/Stone saw onto the
stand so that the saw base lines up evenly
with the retaining walls at each corner (Fig.
2).
Note: To remove the saw from the stand,
follow the same procedure in reverse.
Assembly
Mounting Saw to Stand
FIG. 2
-3-
A
D
E
C
D
B
FIG. 1