Assembly And Installation; Unpacking; Installation - Invacare Madison Plus Manual Del Usuario

5.Assembly and installation

5.1 Unpacking

Open the cardboard box carefully when installing (do not
use sharp objects when opening).
The cardboard packaging protects the Lift-out chair during
transport:
- open the flaps of the cardboard box;
- remove the armchair's unassembled backrest;
- tear open the cardboard box at the 4 corners to remove the
armchair;
EN6
- remove the protective plastic film and the anti-humidity
sachets.
Inspect the armchair to check for any damage, nicks, tears or
damage to the frame. If you notice any defects, do not attempt
to use the armchair. Contact the distributor or carrier for
instructions on how to proceed.
Remember to recycle all packaging in appropriate
containers. Keep packaging out of reach of children at all times.

5.2 Installation

Leave sufficient room (approximately 50 cm) behind the
armchair to prevent it from coming into contact with the wall
when in the reclined position.
Make sure the armchair is positioned on a flat level surface.
Do not place your armchair near a staircase.
Never position the armchair near a major source of heat:
(fireplace, electric heater, gas heater, oil heater, etc). Do not
expose the armchair to direct sunlight (UV) for a prolonged
period of time.
1) Assembly
- Remove the transformer from its cardboard box held in
place by a plastic ring under the frame of the chair.
- Connect the power supply cable to the transformer plug (A).
- Connect the mains cable (B) to the transformer and con-
nector, and then connect the mains cable plug to the electrical
power supply in compliance with the applicable standards and
in accordance with the power supply unit voltage.
- Remove the plastic tie that attaches the chair power cable to
the remote control.
- Position both backrest runners simultaneously in the moun-
ting brackets until the backrest locks firmly in place (an audible
click will be heard).
A
A
B