Dometic WAECO PerfectView Serie Instrucciones De Montaje página 32

Mounting the LCD monitor
Observe the following instructions when laying the connection cable:
Feed the connection cable through existing ducts or other openings where possible,

e. g. ventilation grilles. If no suitable ducts or openings are available you will need to
drill a hole of ∅ 20 mm. Check beforehand that there is sufficient space on the other
side for the drill head to emerge (fig. <Waeco<Waeco>2, page 3).
 To prevent damage to the cables, when laying them ensure that there is always a
sufficient interval to vehicle components which can become hot (lights, heaters, ven-
tilators etc.).
 Wrap insulating tape around every connection on the cable (even inside the vehicle).
 When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection
(fig. <Waeco<Waeco>3, page 3).
Connecting the monitor as a reversing video system (fig. <Waeco<Waeco>d,
page 7)
➤
Lay the connection cable for the monitor bracket on the dashboard.
➤
Insert the plug of the monitor cable (2) into the socket (4) of the connection cable (3).
A
NOTICE! Risk of damage
Make sure the polarity is correct when connecting to a voltage source.
➤
Connect the red and black cables of the connection cable to a suitable voltage sup-
ply:
– Connect the red cable (5) to terminal 15 (ignition).
– Connect the black cable (6) to terminal 31 (earth).
➤
If the monitor is to be activated when reverse gear is selected, connect the green ca-
ble (8) to the positive cable of the reversing light.
I
NOTE
If voltage is present in the green cable (8), the reversing camera will be activat-
ed automatically. The reversing camera has priority.
➤
If the monitor is to be activated e. g. when the indicator is flashing, connect the fol-
lowing control cable to a positive cable of the indicator:
– M5L, M7L: white cable (8)
– M7LX: white cable (8), blue cable (13)
I
NOTE
If voltage is present in this control cable, the following video input will be acti-
vated:
 M5L, M7L: video input C2
 M7LX: video input C2, video input C3
32
PerfectView M5L, M7L, M7LX
EN