Heating Water; Cleaning And Care - AEG EA 150 Instrucciones De Uso

EA150.book Seite 13 Freitag, 5. Dezember 2003 10:47 10
0 Switch on the appliance using the on/
off switch (figure 1/A). Wait until the
appliance has attained its operating
temperature and the orange
temperature indicator has gone out
(figure 1/D).
0 Switch the water/steam selection
switch (figure 1/B) to the symbol
2. Creating steam/frothing milk
0 Pour some milk or other liquid to be
heated into a heat-proof container.
0 Immerse the steam nozzle into the milk
or liquid to be heated (figure 11).
0 Turn the selector dial (figure 1/G) to
the left onto the
appliance will now begin to create
steam. At the beginning some drops of
water may drip out of the nozzle as
well.
Important: So as not to prevent the
steam from exiting, the steam nozzle
must not touch the base of the
container.
0 Stop steam from being emitted by
turning the selector dial (figure 1/G)
back to the right into the "•" position.
0 Place the steamed liquid to one side
and turn the steam selection switch
back to the
seconds. This will remove any milk
residue or residue from other liquids
out of the nozzle. Caution: The steam
is hot.
3
To achieve a fine, creamy milk froth it
is best to use cool low-fat milk.
Making a cappuccino
Fill a large coffee cup from ½ to ¾ full
of espresso. Pour the frothed milk over
the top. Sprinkle a little cocoa over the
milk froth.

3. Heating water

0 Turn the water/steam selection switch
(figure 1/B) to the
0 Place a container under the steam
nozzle (figure 1/H).
0 Turn the selector dial for coffee, steam
and hot water (figure 1/G) to the
.

Cleaning and care

symbol. The
symbol for a couple of
position.
position. Hot water will be emitted
from the steam nozzle.
0 After the desired amount of hot water
has been obtained, turn the selector
dial for coffee, steam and hot water
(figure 1/G) to the "•" position.
Daily care
We recommend that, each day prior to
the first and after the last espresso, you
rinse out the system for approx. 10
seconds without espresso grounds in
order to prevent particles coffee from
becoming lodged in the appliance.
Proceed as for making an espresso, but
without using espresso grounds.
0 Afterwards, turn the selector dial
(figure 1/G) briefly to the
0 Pour any remaining water out of the
water tank.
Cleaning (figures 12, 13)
1
Prior to cleaning the appliance, switch
it off and disconnect the power plug.
Do not clean any part of the
appliance in the dishwasher.
0 Wipe all the appliance's surfaces using
a damp cloth. Do not use harsh or
scratching cleaning agent.
0 Rinse out the water tank at least once
a week in normal rinse water.
0 Clean the 1-cup filter and the 2-cup
filter from time to time using a brush.
Steam nozzle
0 Remove the attachment from the
steam nozzle and rinse the attachment
in normal rinse water.
0 Wipe the steam nozzle clean using a
damp cloth. You can use the
maintenance guide (figure 1/K) to
screw off the nozzle head to clean it or
decalcify it.
Drip grating and drip tray
The drip tray must be emptied when
the level indicator (figure 1/S) is
protruding above the drip grating.
g
position.
13