Humatechnik lisa RF time flash Instrucciones De Servicio página 12

Snooze Alarm
Press the Light/Snooze button to sus-
pend an alarm which is in progress.
The alarm is triggered again after
about 5 minutes.
Switching on the clock face illumin-
ation
Press the Light/Snooze button to
switch on the clock face illumination
for about 6 seconds.
Switching the flash on and off
The flash feature of the lisa RF time-
flash alarm clock can be switched on
and off.
To switch the flash off, please proceed
as follows:
- Switch off the alarm and the tone
(Switches are pressed in, the green
edge is not visible).
- Now press the alarm repeat button
on the top side of the alarm clock
and keep it held down.
- Press six times on the left tone ad-
juster button (situated at the right
side of the volume control).
When pressing the button you will
hear a beep tone.
- Let go of the alarm repeat button.
The flash is now switched off.
English 12
To switch the flash on, please pro-
ceed as described above, but press
six times on the right tone adjuster
button.
The flash is now switched on again.
Setting the correct radio channel
A special digital transmission pro-
cess ensures that the radio signals
are received error-free. This process
also makes it possible to set 10 dif-
ferent radio channels. When supplied
from the factory, the »lisa RF time
flash« is set to channel 0. It is only
necessary to set units to other chan-
nels if you have several different users
operating units in the same building.
Set the channel you want by adjus-
ting the channel selector switch on
the underside of the unit to the re-
quired channel number. Use a small
screwdriver to adjust this switch. All
transmitters and receivers within your
system must be set to the same chan-
nel.
Fig. setting the correct radio channel.