Carrying Out A Measurement - Trotec PC200 Manual De Instrucciones

–
PARTICLE SET measurement settings
The following submenus are available in the "PARTICLE SET" menu:
Sample Time
Start Delay
Channel Display
Ambient Temp/%RH
Sample Cycle
Sample Mode
Interval
Level Indication
Example: Set measurement duration
1. Use the buttons to select the "Sample Time" menu and then press
"ENTER" to confirm.
– The "Sample Time" menu opens.
2. Press the "ENTER" button.
– The measurement duration glows blue.
3. Use the buttons to set the measurement duration and confirm by
pressing "ENTER".
– The measurement duration not longer glows blue. Set set value is saved.

Carrying out a measurement

1. Slide the protective cap of the temperature sensor down.
2. Press "ENTER" in the start screen.
– The "Measurement" screen opens.
3. Press the "RUN/STOP" button.
– Depending on the configuration, start delay, measurement duration and
measurement interval are shown consecutively.
– The number of measured particles and their size is shown.
After each measurement, a measurement log is automatically created. If you also
want to take a photo or record a video, proceed as described in the next sections.
GB
Set measurement duration
Set start delay
Show/hide individual particle sizes by pressing
"ENTER"
Enable/disable temperature
humidity
Set number of measurement repetitions
Set method of analysis
cumulative, differential, concentration
Set measurement interval
Select particle size for indicator scale for
particle burden
Carrying out a measurement and taking a photo
1. Press "ENTER" in the start screen.
– The "Measurement" screen opens.
2. Press "F1" to start the acquisition function.
3. Press "F1" again to start the photo function.
– The current camera image is shown behind the measurement data.
4. Press the "RUN/STOP" button.
and relative
– Depending on the configuration, start delay, measurement duration and
measurement interval are shown consecutively.
– The number of measured particles and their size is shown.
5. Press "F1" to take a photo of the current display.
– The photo is shown. The measurement continues in the background.
– You can save the photo by pressing "F1" or delete it by pressing "F3"
Carrying out a measurement and recording a video
1. Press "ENTER" in the start screen.
– The "Measurement" screen opens.
2. Press "F1" to start the acquisition function.
3. Press "F3" to start the video function.
– The current camera image is shown behind the measurement data.
4. Press the "RUN/STOP" button.
– Depending on the configuration, start delay, measurement duration and
measurement interval are shown consecutively.
– The number of measured particles and their size is shown.
5. Press "F2"
– The duration of the video is shown at the top of the screen.
6. Press "F2"
– The message "Saving File" appears in the display. The video is saved.
Operating manual – Particle counter PC200
to start recording a video.
to stop recording the video.
.
B - 5