Vimar ELVOX PIXEL UP 40405 Manual De Usuario página 16

PIXEL UP: 40405 - 40425
3. Entry control
The display gives feedback on the access control mode operation.
This mode is used to activate a previously configured command (e.g. lock, relay, etc.).
Press the button and the display to go into "Code Entry" mode.
Each time a digit button is pressed, the display will show the digit for a short time and then overwrite it with an asterisk.
The code entered is confirmed by pressing
The key is used to cancel any digits entered or if no digits have been entered, to return to the home page.
The device returns
the status information
associated with the
entry control phase:
After entering a code
two signals appear,
depending on the result
of the operation.
If the code corresponds
to the lock activation
of the local entrance
panel, the door open
icon is displayed
instead of the
completed icon.
16
(Cancel) key
again.
Code
Confirm
Delete
Access to the mode
Entering code
for Entry control
Done Wrong Code
Done Not completed
(Key) key
Code Code
Confirm Confirm
Delete Delete
Waiting for
confirmation
Door Opened
Door Opened
EN