Preparation Of Top Cabinet; Adapting Blower For Outside; Back Exhaust - GE JVM7195 Manual De Instalación

Spacing for Toggles More
Than Wall Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
3
Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch
the bottom of the cabinet when pushed flush against
the wall and that the plate is properly centered under
the cabinet.
CAUTION:
plate and the wall.
Tighten all bolts. Pull the plate away from the wall
4
to help tighten the bolts.
B3
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
Read the instructions on the TOP CABINET
TEMPLATE.
Tape it underneath the top cabinet.
Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION:
Installation Instructions
Bolt End
16
ADAPTING BLOWER FOR
B4
1 Remove the blower motor screw that holds the
blower plate to the oven. Lift the front of the blower
plate to install the blower.
Blower
Motor Screw
2 Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
BEFORE: Fan Blade
End A
Rotate blower unit counterclockwise 180°.
3
Before Rotation
Back of
Oven
4 Gently remove the wires from the grooves.
Reroute the wires through grooves on other side
of the blower unit.
Before Rerouting
Wires Routed Through Right
Side
Blower Plate
Blower
Motor Screw
End B
After Rotation
Back of
Oven
After Rerouting
Wires Routed Through Left
Side