Adapting Blower For Recirculation - GE JVM7195 Manual De Instalación

C3 ADAPTING BLOWER
FOR RECIRCULATION
NOTE: The exhaust adaptor with damper is not
needed for recirculating models. You may want
to save them for possible future use.
Carefully pull out the blower unit. The wires
1
will extend far enough to allow you to adjust
the blower unit.
2 Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
BEFORE: Fan Blade
End A
Roll the blower unit 90° so that fan blade openings
3
are facing out the back of the oven.
AFTER: Fan Blade
Forward
NOTE: Make sure wires remain routed in the grooves
of the motor frame.
Installation Instructions
Blower Plate
Blower
Motor Screw
End B
Back of
Oven
Back of
Oven
Place the blower unit back into the opening.
4
WARNING:
can cause injury or death. Do not pull or stretch
not pinched.
Close the blower plate. Secure with the screw
5
removed earlier.
Blower Plate
20
Back of
Oven
Screw