Start-Up; Filling Self-Priming Pumps With Water; Checking How Easily The Pump Rotates - Speck BADU Top Manual De Uso

Pos : 86 /T echnisc he Dokumentation/Betriebsanl eitung/Inbetri ebnahme/Inbetriebnahme @ 0\mod_1427956937430_370.doc x @ 27298 @ 1 @ 1
6

Start-up

N O T IC E
The pump/unit can be damaged if it runs dry!

Ensure that the pump/unit is always full of water. This also
applies to checking the rotation direction.
Pos : 87 /T echnisc he Dokumentation/Betriebsanl eitung/Inbetri ebnahme/Sel bstansaugende Pumpe mit Wass er füllen @ 0\mod_1427959830385_370.doc x @ 27313 @ 2 @ 1
6.1

Filling self-priming pumps with water

1. Remove the lid. See chapter 8.1 on page 25.
N O T IC E
High concentrations water treatment chemicals can damage the
pump!

Do not place water treatment products, particularly in tablet
form into the strainer basket.
2. Fill the pump with clean water up to the inlet connection.
N O T IC E
Tightening the lid too tight when using the opening device will
make it difficult to re-open the lid.

Only apply normal manual force!
3. Replace and tighten the lid.
Pos : 88 /T echnisc he Dokumentation/Betriebsanl eitung/Inbetri ebnahme/Pumpe auf Leic htgängigkeit prüfen @ 0\mod_1427961952256_370.doc x @ 27328 @ 2 @ 1
6.2

Checking how easily the pump rotates

After longer idle periods, the pump must be checked for how
easily it rotates while it is switched off.

Place a screwdriver in the groove on the end of the motor
shaft on the fan side and turn it.
– or –

If there is not a groove on the end of the motor shaft:
Remove the fan cover and turn the fan wheel manually in the
motor rotation direction.
Pos : 89 /T echnisc he Dokumentation/Allgemei ne Module/#### Sei tenumbruch #### @ 0\mod_1426069111812_0.doc x @ 891 @ @ 1
10|2015
Start-up
EN 21