Magic Chef MCSTCW09W1 Manual Del Usuario página 15

Pull down on the white ring
to divide the adaptor into two parts.
2. Connect the ends of the water supply hoses to the COLD water faucet.
(Refer to Figure 13.) For convenience, use the Quick Connection Adaptor
for connection to the cold water faucet. See instructions for Quick
Connection Adaptor Use in Step 1 above.
3. Tighten the fittings by hand until they are snug, and then tighten them an
additional two-thirds of a turn with a wrench.
WARNING: When you fasten the fittings, DO NOT fasten them too tightly or
apply tape or sealant to the faucets or water supply intakes. This can damage the
fittings. After you have connected the water supply hoses to the faucets, ensure
that they are connected securely by pulling the water supply hoses downwards.
4. Place the unconnected ends of the hoses into a bucket and open the faucets connected to the two water supply
hoses for 10 or 15 seconds to remove any foreign substances from the hoses. Close the faucets before continuing.
5. Connect the ends of the water supply hoses to the water supply intake connections at the top of the washer.
WARNING: The water hose connected to the COLD faucet must be connected to the cold water supply intake.
6. Tighten the fittings by hand until they are snug, and then tighten them an additional two-thirds of a turn
with a wrench.
WARNING: Confirm that the water supply hoses are not twisted or bent. If the hoses are twisted or bent, the
hoses can leak and cause electric shock due to the water leakage. To ensure the correct water usage, connect the
COLD water faucets.
7. Turn on the COLD water supplies and check all the water supply intake and connections the faucets for
water leaks.
Step 4: Connect the Drain Hose
Position the other end of the drain hose. It can be positioned
in three ways. (Refer to Figure 14.)
a. Over the edge of a wash basin. Secure the guide to the
side of the basin wall with a hook or to the tap with
piece of string to prevent the drain hose from moving.
b. In a standpipe the standpipe must be no shorter than
32 in. (81cm) and no longer than 39 in. (100cm).
c. In a laundry tub. The laundry tub must be no shorter
than 32 in. (81cm) and no higher than 39 in. (100cm).
WARNING: Make sure that the connection between the
drain hose and the wash basin, standpipe or laundry tub is
not airtight.
Figure 11
Top Part:
Faucet Fitting
Bottom Part:
Hose Fitting
15
Rubber Gasket
Inner Threads for Outer Threaded Faucet
Outer Threads for Inner Threaded Faucet
a
b
Figure 12
Figure 13
Cold Water
Faucet
Water
Supply Hose
Figure 14
c