DeWalt DXAEC80 Manual De Instrucciones página 15

long as the charger is connected to the battery and plugged into
a functioning AC outlet. The LCD Screen shows the following:
The Bank 1 Indicator flashes. The Digital Display shows "FLO"
indicating that the unit is in Float Charge Mode. The Clamp Icons
and the Battery Icon (with three bars) will light solid.
NOTE: In Float Charge Mode, the Digital Display shows "FLO" by
default. Press the Battery Voltage Button once to show the voltage
(V) of the connected battery. Press the Battery Voltage Button again
to show the charge status of the battery as a percentage (%) of
full. Pressing the Voltage Button cycles through different charging
status views of the connected battery.
5. When disconnecting the battery charger, unplug the AC Power
Cord, remove the clamp from the vehicle chassis, and then remove
the clamp from the battery terminal.
Multi-Bank Battery Charging
1. Plug the battery charger's AC Power Cord into a functioning
AC outlet. A beep will sound and the LCD Screen will show the
following:
The Bank 1 Indicator flashes to indicate that the unit is in Single-
Bank Mode (the default mode) and that Bank 1 is selected. (The
DXAEC80_DXAEC80CA_ManualENFRSP_082616.indd 15
Bank 2 panel remains blank in Single-Bank Mode.) The empty
Battery Icon will light solid to indicate the built-in battery clamps
are not yet connected to a battery.
2. Press the Single/Multi-Bank Selection Button once to select the
Multi-Bank Mode. A beep will sound and the LCD Screen will show
the following:
The Bank 2 Indicator lights solid and the Bank 1 Indicator flashes,
indicating Bank 1 (the default) is selected. The (empty) Battery Icon
will light solid to indicate the built-in battery clamps (Bank 1) are
not yet connected to a battery.
3. Press the Single/Multi-Bank Selection Button again for one second.
A beep will sound and the LCD Screen will show the following:
The Bank 1 Indicator lights solid and the Bank 2 Indicator flashes,
indicating Bank 2 is selected. The (empty) Battery Icon will light
solid to indicate the Clamp Cable Set (Bank 2) is not yet connected
to a battery.
4. Connect the battery charger to the battery using the built-in battery
clamps (Bank 1 only) or the Clamp Cable Set (Bank 2), following the
appropriate set of directions in the "Preparing to Charge" section
at the front of this manual.
Repeat this process for each Bank you will be using.
15
10/19/2016 3:58:06 PM