DeWalt DXAEC80 Manual De Instrucciones página 16

5. Once either or both charging Banks are properly connected to a
battery with regard to polarity, a beep will sound for each Bank
connection and the LCD Screen will show the following to indicate
the unit is in Standby Mode (the bars on the Battery Icon represent
the charge level of the selected battery; and the Clamp Icons and
the Battery Icon light solid):
NOTES:
A. The Bank Indicator of the selected charging Bank flashes.
Toggle between Bank 1 and Bank 2 by pressing and holding
the Single/Multi-Bank Selection Button for one second. A
beep will sound each time the button is pressed.
B. The Digital Display shows the voltage (V) of the battery
connected to the selected charging Bank by default. Press
the Battery Voltage Button once to show the charge status of
the battery as a percentage (%) of full. Pressing the Voltage
Button cycles through different standby status views of the
selected battery.
IMPORTANT: If the clamps of EITHER charging Bank are
incorrectly connected with regard to polarity, the LCD Screen
will go directly to the Bank Indicator that is in fault. For example,
DXAEC80_DXAEC80CA_ManualENFRSP_082616.indd 16
if the Bank 1 connections were incorrectly connected with regard
to polarity, the LCD Screen would show the following:
The Bank 2 Indicator lights solid and the Bank 1 Indicator flashes,
indicating Bank 1 is currently selected. The (empty) Battery Icon and
the Clamp Icons light solid. The Alarm Icon, Reverse Polarity Icons,
and the "+" and "–" signs on both the Clamp Icons and the Battery
Icon flash. The unit emits a continuous warning sound until the
clamps are disconnected (or the Clamp Cable Set is disconnected
when using Bank 2). Remove the clamps (or the Clamp Cable Set
when using Bank 2) and then reconnect the clamps properly.
6. When all connections are made correctly, select the desired Bank
and press the Battery Charge Button to begin charging the battery
connected to that charging Bank. The LCD Screen will show the
following:
The selected charging Bank Indicator flashes. (For example, the
Bank 2 Indicator lights solid and the Bank 1 Indicator flashes when
displaying the charge status of the battery connected to Bank 1.)
The Digital Display shows the output current that is charging the
selected battery. The Clamp Icons light solid and the bars on the
Battery Icon will change from empty to solid (bottom to top) to
indicate the selected charging Bank is in Charging Mode.
16
10/19/2016 3:58:07 PM