Radio Operation - Aiwa CDC-X917M yu Manual De Instrucciones

Muting button beep sounds
1
Turn off the unit.
2
Press and hold SEL until "BEEP" appears in the
display.
3
Press + or – to select "ON" or "OFF".
4
Press SEL.
The unit turns off.
Setting the clock
1
Press and hold SEL until the clock indicator flashes
in the display.
2
Press TUNEk (to set hour) or TUNEi (to set
minute) and press + or –.
3
Press SEL.
Displaying the clock
1
Press DISP.
To return to the former display, press DISP again.

RADIO OPERATION

Tuning in to a station
(Seek/Manual Tuning)
Band indicator* Frequency indication
Local indicator
*"F" means FM, and "A" means AM.
1
Press FUNCTION repeatedly to select the desired
band (F1, F2, F3, A1 or A2).
2
Press TUNEi (to move to higher frequencies) or
TUNEk (to move to lower frequencies) to tune in to
a station.
"ST" appears in the display when an FM station is
broadcasting in stereo, and receiving conditions are
good.
Seek Tuning and Manual Tuning
• Press and hold TUNEi or TUNEk until Seek
Tuning starts.
The unit locates a station automatically (Seek
Tuning).
3 3
ENGLISH ENGLISH
Monaural mode
When FM signals become weak, or FM reception
becomes poor, the unit automatically switches to
Monaural mode to reduce noise.
Local mode
Local mode allows you to tune in only to strong stations
during Seek Tuning.
1
To return to Distant mode, press LO again.
"LO" disappears and the unit tunes in to all receivable
stations.
Using preset stations
You must preset stations before you can tune in a station
using preset station number buttons.
Presetting stations automatically
(Auto Memory)
1
Stereo indicator
2
To cancel automatic presetting, press PS/A.ME again.
Checking the preset stations (Preset Scan)
1
To cancel Preset Scan, press PS/A.ME again or any
preset station button.
• Press TUNEi or TUNEk repeatedly to search for
a desired station while increasing or decreasing
the frequency step by step (Manual Tuning).
To stop Seek Tuning, press TUNEi or TUNEk
again.
Press LO before you start seek tuning.
"LO" appears in the display.
Preset station buttons 1 – 6
Press FUNCTION repeatedly to select the desired
band (F1, F2, F3, A1 or A2).
Press and hold PS/A.ME until automatic presetting
starts.
The unit automatically stores up to 6 stations for
each band.
After completion of automatic presetting, the unit
tunes in to all the stations stored on the preset
station buttons in order (Prest Scan).
Press PS/A.ME briefly.
Each preset station will be tuned in for 5 seconds in
order.
Preset station number