Therma-Liner Preparation; Inspecting Before Operation; Operating Instructions - Ameda PENGUIN Instrucciones De Uso

4.4 THERMA-LINER PREPARATION

1. At the beginning of a shift, take out one Therma-Liner per user.
2. Using a permanent marker, enter the following information onto the Therma-Liner:
a. Patient Information
3. Open the water compartment (blue zipper) and fill to water line.
4. Pinch one end of the blue zipper between your thumb and forefinger and slide
down the length of the zipper to close the water compartment.
5. Repeat to ensure a proper seal. This compartment will remain sealed for the
duration of the 12 hour shift.

5. INSPECTING BEFORE OPERATION

Inspect the product for damage. Do not use if damaged.
Call Ameda CustomerCare at 1.877.99.AMEDA (26332).

6. OPERATING INSTRUCTIONS

1. Flip the power switch into the on position.
2. Place the feeding container into the inner compartment (orange zipper) of the
Therma-Liner and push it to the bottom. Press firmly along the entire orange
zipper to encompass the container as much as possible. Use care when
removing and re-inserting feeding containers to prevent damage to the interior
water compartment.
3. Place the prepared Therma-Liner in the well with the sealed opening at the top.
4. Press Warm/Off Button to begin.
5. Select the warming mode of interest:
a. Warm: Room Temp/Refrigerator to Feed
Press Warm/Off Button Once
b. Warm: Frozen to Feed
Press Ice Cube Button Once
c. Thaw
b. Date/Time c. Information
Press Ice Cube Button Twice
9