How To Assemble - Richell L6 Manual De Instrucciones

How to assemble

1.
Attach Panels
① Locate the hole on the bottom of the
Panel and insert the Wood Dowel on the
Coupling Rod in the direction as shown.
2.
Insert Hole pins
Insert 2 Hole pins in to the Holes on top
of the Coupling Rods as shown.
3.
Insert Caps
After selecting your desired configuration,
insert Caps as shown. Check to make sure
each Cap is in position.
Cautions!
l Caps can only be inserted at 90 or 180 degree angles.
l There will be a small gap between Panel and Cap.
4.
Level the product using the Adjuster
To make sure the product is placed
properly on the floor, turn the Adjuster
Knob on the bottom of the Coupling
Rod until it touches the floor.
② Attach the top of the Coupling Rod to the Panel as shown.
(After inserting Wood Dowel, do not force the Coupling
Rod by twisting/turning).
Wood Dowel
Hole
Hole pin
Hole
90 degree angle 180 degree angle
3
Adjuster Knob Adjuster Knob
Tighten Tighten
(Lower) (Lower)
Loosen Loosen
(Higher) (Higher)