Adjusting The Vise - Bosch 3814 Instrucciones De Funcionamiento

ADJUSTABLE DEPTH STOP BOLT
Your tool is equipped with a depth stop bolt. As the wheel
wears, or when replacing a wheel it will be necessary to make
this adjustment.
TO RAISE WHEEL, Loosen nut on depth stop bolt and rotate
bolt counter-clockwise with the wrench provided.
TO LOWER WHEEL, rotate depth stop bolt clockwise. Attention:
To maintain adjustment, securely tighten nut on the depth stop
bolt with the wrench provided.
DEPTH STOP
ADJUSTMENT
BOLT
LOCK NUT
CHANGING CUTTING ANGLE
1. Loosen the vise stop adjustment bolts with the wrench
provided, (Fig. 5), DO NOT REMOVE.
2. Align desired angle on vise stop scale with index line in base,
and securely tighten bolts with the wrench provided.
OPENING ADJUSTMENT
1. Loosen vise stop adjustment bolts with the wrench provided
(Fig. 5), DO NOT REMOVE.
2. Slide vise stop forward or backward to desired location, and
securely tighten bolts with the wrench provided.
FIG. 5
CRANK
SCREW SHAFT

Adjusting the Vise

QUICK RELEASE
LEVER
BASE
VISE STOP
ADJUSTMENT
BOLTS
CARRYING THE TOOL
1. Lower arm as far as it will go, and attach the hold down chain
to the hook provided and release tension on arm.
2. Raise the depth stop adjustment bolt until the bolt touches
the arm as shown in (Fig. 4) to prevent any movement or
bouncing of the arm.
Be certain that the hold down chain is tightly
! CAUTION
secured to the base and arm for transporting. If
the abrasive cut off machine is carried in the open position the
depth stop may be damaged.
FIG. 4
HANDLE
HOLD DOWN
CHAIN
QUICK RELEASE LEVER
To release work, turn crank to loosen, lift quick release lever up
(Fig. 5), and pull screw shaft away from work.
To lock work, push screw shaft toward work, lower quick release
lever and turn crank clockwise to tighten.
MAXIMUM CUTTING DEPTH
To obtain maximum cutting depth, position vise stop so material
being cut is approximately centered under wheel, when wheel is
lowered all the way down.
VISE STOP
SCALE
-7-
HOOK
WRENCH
INDEX
LINE