Power Sources; Dimmer Function - Roadstar CLR-2615 Manual De Instrucciones

1 English
LOCATION OF CONTROLS
1. MEM BUTTON
2. TUNING - / TIME -
3. TUNING + / TIME +
4. SNOOZE / SLEEP / DIMMER
5. VOLUME - / ALARM 1
6. VOLUME + / ALARM 2
7. POWER ON - OFF / ALARM SETTING
8. PM LED
9. LED DISPLAY
10.ALARM 1 ON INDICATOR
11.ALARM 2 ON INDICATOR
12.SPEAKER
13.FM ANTENNA
14.BACK-UP BATTERY
15.DC INPUT

POWER SOURCES

This unit works with an AC/DC adaptor of 6.5V - 600mA. Connect the adaptor to the
DC input (15) at the back of the unit and into a wall AC power outlet.
Check that the rated voltage of the adaptor matches your local voltage.
Make sure that the DC plug is fully inserted into the appliance.
Notes:
Use only the supplied AC/DC adaptor. Using other types of adaptor may damage
•
the unit.
Do not touch the AC/DC adaptor with wet hands.
•
BATTERY BACK-UP POWER FAILURE PROTECTION
This radio has a battery back up circuit that will keep the correct time and alarm set-
tings in the event of a temporary power interruption.
Install 1 x CR2025 battery (not included), into the battery compartment located on the
bottom of the unit.
Note: We recommend an alkaline battery for longer usable life.
Change the battery every 9 to 12 months for best result and avoid possible battery
leakage.
If power is temporarily interrupted the display will blink and the radio will not play.
However, the battery back-up circuit will continue to maintain the clock and alarm set-
tings. When power is restored the clock will display the correct time and alarm set-
tings, and no adjustment is necessary.
DISPLAY
Normally the LED DISPLAY indicates the TIME.
Press [MEM] button (1) to show DAY OF THE WEEK.
•
Press [TIME -] buttons (2) to show DAY, MONTH.
•
Press [TIME +] buttons (3) to show YEAR.
•

DIMMER FUNCTION

Press repeatedly the [DIMMER] button (4) to adjust the display intensity.