Water Draining/ Separation Of The Unit From The Toilet Bowl - SmartBidet SB-3000 Manual Del Usuario

Water Draining / Separation Of Unit From The Toilet Bowl
7
Please follow the instructions below when moving or separating the unit from the toilet for cleaning purposes.
1
Disconnect the power plug.
2
Shut the water supply valve.
3
Push and hold the button to the left of the nozzle to
completely drain the water from the water tank.
4
Loosen the nut on the hose that is connected to the unit, and
then separate the electronic toilet seat from the toilet in the
following order as illustrated.
Do not turn the seat upside-down. This can cause damage to the unit as well as fire hazard.
ᆞWhile pushing the button (area shown as an arrow) push the electronic toilet seat slightly toward to the front
and then the body unit will begin to slide out. Next, lightly pull the unit toward the front and it will detach
from the toilet.
5
Disconnect the T-valve from the water tank.
6
Connect the water hose to the toilet which was disassembled while installing the electronic toilet seat,
and turn the water valve to the left to open it. See if there is any leaking from the water hose connection.
7
Re-install the toilet seat and lid that was separated when installing the electronic toilet seat.
ᆞAs explained above, steps 1~4 are instructions for separation of the unit for basic cleaning purposes,
and steps 5~7 are instructions for separation when moving, etc.
18