Assembly And Adjustment - VITO PRO-POWER SDS-MAX Manual De Instrucciones

EN
Make sure that extension cord
is in good condition before
using. Always use the cord that
is suitable for the power input
of your tool (see technical data
on name plate). The minimum
conductor size is 1.5mm 2.
DESCRIPTIOn (FIG. A).
Your heavy-duty rotary
hammer has been designed for
professional rotary drilling and
hammer drilling as well as light
chipping.
1. Variable speed ON/OFF switch.
2. Mode selector.
3. Safety lock.
4. Steel ball support.
5. Front cover.
6. Side handle.
TORQUE LIMITInG
CLUTCH
These tools are equipped with a
torque limiting clutch that reduces
the maximum torque reaction
transmitted to the operator in
case of jamming of a drill bit. This
feature also prevents the gearing
and electric motor from stalling.
The torque limiting clutch has
been factory-set and cannot be
adjusted.
ASSEMBLY AnD
ADJUSTMEnT
Prior to assembly and adjustment
always unplug the tool. N.B.
nOTE:Accessories mentioned in
this manual may not necessarily
be included in your pack.
Selecting the Operating Mode
(Fig. B). The rotary hammer
drill can be used in the following
operating modes. Hammer
drilling: simultaneous rotating
and impacting for concrete and
masonry drilling. Hammer only:
for light chipping, chiseling and
demolition applications. In this
mode the tool can also be used
as a lever to free a jammed drill
bit. Select the required operating
mode by depressing the safety
lock (3) and rotating the mode
selector switch (2) until it points
to the symbol of the required
mode. Release the safety lock
and check that the mode selector
switch is locked in place. Do
net select the operating mode
when the tool is running. For
screw driving, refer to section
"Instructions for use".
InDEXInG THE CHISEL
POSITIOn
The chisel can be indexed and
locked into 51 diferent positions.
Depress the safety lock (3) and
rotate the mode selector switch
(2) until it points to the "'D2bit
rotation"Position. Rotate the
chisel in the desired position. Set
the mode selector switch (2) to
the "hammering only position.
Twist the chisel until it locks in
position.
InSERTInG AnD
REMOVInG SDS-MAX
ACCESSORIES (FIG.C)
Your rotary hammer drill uses
SDS-MAX accessories (refer to
the inset in fig.C for a cross-
section of an SDS-MAX bit
shank). We recommend using
professional accessories only.
Clean and grease the bit shank.
Insert the bit shank into the tool
steel ball support (4). Push the bit
to check if it is properly locked.
The hammering function requires
the bit to be able to move axially
several centimeters when locked
in the bit holder. To remove a
bit pull back the tool bit holder
locking sleeve (4) and pull out
the bit.
15