Descargar Imprimir esta página

Troubleshooting - Num'axes PIE1035 Manual De Instrucciones

Cámara trampa

Publicidad

Idiomas disponibles

Idiomas disponibles

Photos (still images)
Videos
Trigger Time
Serial Number (camera ID)
Operation on fixed times
Memory
Screen
Voltage
Batteries
External power
Interface
Operating Temperature
Storage Temperature
Waterproof Spec
Dimensions
Weight
12.

Troubleshooting

Problems
The device cannot be turned on.
The photos/videos cannot be saved.
The device automatically powers off.
Bad focusing.
The memory card doesn't work.
13.
After-sales service
Should your product stop working or develop a fault, first read this guide over, and then check the batteries and
replace them if necessary. Also check that you are using the product correctly.
If the problem persists, contact your distributor or check out on www.numaxes.com.
You can also contact NUM'AXES at +33.2.38.69.96.27 or export@numaxes.com.
PIE1035 - Indice A – Novembre 2018
Picture size: 3MP, 5MP, 8MP, 12MP or 16MP
Files format: JPEG
Multi-shot: programmable from 1 to 3 photos per trigger
Video size: VGA (640x480), HD (1280x720) or Full HD (1920x1080)
Files format: AVI
Video length: programmable from 10 seconds to 5 minutes
Less than 1 second
Programmable (4 digits)
Yes (TIMELAPSE mode)
SD/SDHC card (up to 32GB) | Class 4 or higher
1.3" LCD
DC 6V
8xAA
Input AC 100V-240V/50-60HZ | Output DC 6V/2A
USB port | SD card slot | DC port
-15°C to +60°C | +5°F to +140°F
-30°C to +70°C | -22°F to +158°F
IP54
150 x 112 x 66 mm | 5.9 x 4.4 x 2.6 in.
265g | 12.9 oz. (without batteries)
Possible causes
Batteries improperly installed.
No power.
Interrupted power before they were
saved.
Full SD card.
No power.
The lens is dirty.
The memory card is protected.
Format error.
Damaged memory card.
Solutions
Properly install the batteries making
sure to follow the instructions in this
guide.
Replace the dead batteries with new
ones.
Insert a new SD card.
Replace the dead batteries with new
ones.
Clean the lens with a soft cloth.
Make sure the write protection
switch on the side of the card is not
in the LOCK position.
Format the memory card.
Replace the memory card.
20/44

Publicidad

Solución de problemas

loading