Cleaning The Filters; Troubleshooting; Technical Specification - Bionaire BAP001X Manual De Instrucciones

several times until the timer active icon
You may also cancel the timer by turning the unit off
using the on/off button

CLEANING THE FILTERS

We recommend regular filter cleaning for optimal
performance.
• Every few weeks, check the condition of both
filters.
• After approximately 3 months of operation, the
filter service indicator icon
the LCD display to alert you to clean the filters
before further use.
• Depending on use, the filters should be
replaced after approximately 12 months.
Pre-filter
If you are replacing the filter, remove any packaging
from the new filter before fitting.
1. Switch off and unplug your air purifier from the
supply socket.
2. Referring to figure 2, press the rear grille latch
down and remove the rear grille
S
3. Remove the pre-filter
rear grille.
4. Wash the pre-filter in warm soapy water.
5. Allow the filter to dry naturally on a flat surface.
6. Once thoroughly dry, refit the pre-filter into the
rear grille then replace the rear grille onto your
air purifier.
HEPA-type filter
If you are replacing the filter, remove any packaging
from the new filter before fitting.
IMPORTANT: Do not use water, household purifiers
or detergents to clean the filter. The filter may appear
discolored, even after vacuuming. This is normal and
does not affect performance in any way.
1. Switch off and unplug your air purifier from the
supply socket.
2. Referring to figure 2, press the rear grille latch
down and remove the rear grille
S
3. Remove the HEPA-type filter
purifier.
4. Using your vacuum cleaner, run the brush
attachment along both sides of the filter and
clean between the pleated layers.
5. After cleaning, refit the HEPA-type filter then the
rear grille.
goes out.
J
.
F
will appear on
K
.
T
from the inside of the
U
.
T
from your air
V
Resetting the filter service indicator icon
1. With your air purifier switched on, reset the filter
service indicator icon
object (such as a pin or paper clip) into the
hole for the filter reset button
service indicator icon goes out.

TROUBLESHOOTING

Problem
The unit will not
operate
Decreased air flow • Make sure that nothing is
Filter appears dirty,
even after vacuum-
ing clean
The filter service
indicator icon is still
on after cleaning
the filters.

TECHNICAL SPECIFICATION

For all technical and regulatory information with
regards to your product specifications under Eco-
Design Regulation No 206/2012, please contact our
consumer help line or visit www.bionaireuk.co.uk.
SPARE PARTS
HEPA-type filter
Pre-filter
UK - Filter Sales Order Line - 0870 759 9000
6
by inserting a small
K
until the filter
A
Solution
• Make sure that the unit is
plugged in and switched
on
blocking the air inlet or air
outlet.
• Check the condition of the
filters and clean them if
necessary.
• Make sure that the air
intake grill is at least 30 to
90 cm from the wall.
This is normal and does
not affect performance in
any way. A new filter is not
necessary.
See the Resetting the filter
service indicator icon section
in these instructions.
91382
91383