Installation - Vortice VORT-KRYO POLAR Manual De Instrucciones

ENGLISH

Installation

Installation of hot air extraction hose.
Use the window panel (fig.5)
5 5
Installation of hot air extraction hose
Use the window panel (fig.4)
- Fit the rounded connector (13) to the end of the hose
(10).
- Insert the end of the hose into the hole in the panel
(12).
- If the panel is too big, cut it to fit the window.
- Extract the hot air through the window or wall (fig.6 )
6 6
- Fit the rounded connector (13) to the end of the
extraction hose.
- Make a hole (of more than 152 mm diameter) in the
window or wall to accommodate the rounded
connector.
When the appliance is disconnected from the window or
wall, use the blanking cap (14) to cover the hole.
14
The hot air extraction hose supplied with the appliance
can be extended by 300 to 1500 mm (figs 7,8); It is best
to use the smallest possible extension (fig.9).
7 7
8 8
9 9