Belt Adjustment - Sears CRAFTSMAN 536.886261 Manual Del Usuario

BELT ADJUSTMENT
Traction Drive Belt
The traction drive belt has constant
spring pressure and does not require
an adjustment. If the traction drive belt
is slipping, replace the belt. See "How
To Replace The Belts" in the Mainte-
nance section.
Auger Drive Belt
If your snow blower will not discharge
snow, check the control cable adjust-
ment. If it is correct, then check the
condition of the auger drive belt. If it is
damaged or loose, replace it (see Belt
Replacement in this section of the
manual).
1. Disconnect spark plug wire.
2. Remove screw from belt cover,
Remove belt cover (see Figure 19).
3. Loosen nut on auger idler pulley
and move auger idler pulley towards
belt about 1/8 inch (3 ram) (see
Figure 22).
4. Tighten nut.
F-011050L
5. Have someone engage auger drive
clutch. Check tension on belt (op-
posite idler pulley). Belt should de-
flect about 1/2 inch (12.5 mm) with
moderate pressure Figure 20). You
may have to move idler pulley more
than once to obtain the correct ten-
sion.
Auger
Drive
l "_-- Engine
--_ _ Pulley
J i_ O 1/2 inch
,._ \_.j (12.5mm)
idler _,.._('/tc /', _-"_ Deflection
P°"°Y 1o, "
Engaged ___
Figure 20
6. Reinstall belt cover.
7. Whenever belts are adjusted or re-
placed, the cables will need to be
adjusted. (See Cable Adjustment in
this section of the manual).
21
8. Attach the spark plug wire.
HOW TO REPLACE THE BELTS
The drive belts are of special construc-
tion and must be replaced with original
factory replacement belts available from
your nearest authorized service center.
Some steps require the assistance of a
second person.
How To Remove the Auger Drive Belt
If the auger drive belt is damaged, the
snow thrower will not discharge snow.
Replace the damaged belt as follows.
1. Disconnect the spark plug wire.
2. Loosen the bolts on each side of
the bottom panel (see Figure 21).