Global 246099 Manual Del Usuario página 3

User's Manual
OPERATING INSTRUCTIONS
IMPORTANT
THIS HEATER IS FOR USE ON THE FLOOR ONLY.
This heater comes with a grounded (3 blade) plug for use on 110-120 volts AC.
The grounded plug must be used with a grounded outlet. Do not use an adapter
in a 2-slot wall outlet unless the ground plug of the adapter properly connects to
a building ground. Using heater without properly grounded outlet or adapter
could result in an electric shock hazard.
Operation
1. Plug the heater cord directly into a
standard grounded 120-volt AC outlet.
Operate the heater in the upright
position with its rubber feet on the floor.
The plug must fit tightly into outlet. A
loose fit will cause overheating and
damage to the plug. During normal use,
however, the plug may feel warm.
2. Turn the setting control knob to the
"High" position to provide the
maximum heat output.
3. Turn the thermostat knob clockwise
(right) to "HIGH". The heater will begin
heating and the fan will start blowing
warm air.
TO RESET OVER-TEMPERATURE CONTROL
This heater is equipped with a built-in over-temperature safety switch that will turn the heater off if overheating occurs. An alarm
indicator will then light up for your notification.
To reset the heater, turn control to OFF, then remove plug from outlet, wait until heater has cooled and the condition that caused
the overheating is corrected, the safety switch will then reset.
SPECIFICATIONS
CLEANING AND MAINTENANCE
1. Before any cleaning, make sure that:
a. The heater is turned OFF.
b. Disconnect power supply at source by removing plug from power outlet.
c. Your heater is now ready to be cleaned.
2. Regular Cleaning:
a. Do not use cleaning liquid or other chemicals to spray on the unit.
b. Interior dust can often be removed by using a vacuum cleaner with a crevice tool attachment.
DO NOT ATTEMPT TO OPEN THE UNIT.
c. To clean the enclosure, use a clean, soft and lightly damp cloth to gently wipe off the dirt from the surface of the unit.
Be sure not to wet the heating element and the switches. Allow the unit to dry completely before using it.
CAUTION: DO NOT ALLOW WATER TO RUN INTO THE INTERIOR OF THE HEATER AS THIS COULD CREATE A FIRE OR
ELECTRIC SHOCK HAZARD, DAMAGING THE UNIT.
STORAGE
1. Perform the cleaning procedures described in "Cleaning/Maintenance".
2. Wipe all parts to dry.
3. Pack heater in a plastic bag.
4. Keep in a cool, dry place.
Portable Electric Heater
4. When the room temperature reaches
the desired comfort level, slowly rotate
the thermostat knob counterclockwise
(left) until the heater shuts off. At this
setting, the heater will automatically
cycle on and off to maintain this
temperature.
NOTE: Do not force the knob beyond
its normal stopping position. Only minor
adjustments to the thermostat should be
necessary to maintain the desired com-
fort level. Turning clockwise will increase
the room temperature and counterclock-
wise will decrease the temperature.
Model Number
Power Supply
Power Consumption
Grounding
Pin
5. To conserve energy, the heater may
6. When heater is not needed, turn
IMPORTANT: The heating coils on your
heater do not glow. Coil elements are
normally dark. Air movement through
these coils prevents glowing while
providing comfortable heat, similar to a
forced-air furnace. Some glow may
occur where the air movement does not
directly touch the coils.
246099
120 volts AC, 60Hz
1000/1500W
3
A
operate at lower wattage by turning
control knob to the "LOW" position.
selector switch to the "OFF" position.
Then remove the plug from outlet.
B