Sleep Mode / Power Saving Mode; Time-Delayed Switch-Off; Cleaning The Filter Element; Child Lock - Profi Care PC-LR 3076 Manual De Instrucciones

Sleep Mode / Power Saving Mode

• Press the button to enter sleep mode / power saving
mode. Both the display and the coloured ring go out
while the "SLEEP" control lamp lights up. The appliance
is operating in power level .
• As soon as a button is pressed, the display switched on
again and the energy-saving mode is deactivated.

Time-delayed Switch-off

You can set a time-controlled switch-off for the appliance.
• Use the TIMER button to select a time setting between
and .
• Upon expiry of the timer, the appliance will switch off
automatically.
WARNING:
• Always pull the plug before cleaning and maintenance.
• Never immerse the motor housing in water for cleaning. It could
result in an electric shock or fire.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Clean the motor housing with a dry cloth, without
additives.
You can moisten the cloth slightly to wipe away extreme
soiling.
• When "FILTER" appears on the display, it should be
cleaned or replaced.
NOTE:
Despite this message, the appliance may still be
operated with confidence. Once you have cleaned or
replaced the filter, simultaneously press and hold the
TIMER and the SWITCH button for 3 seconds, until
"FILTER" disappears from the display.

Cleaning the Filter Element

1. To remove and install the filter element, proceed as
described in the following section "Replacing the Filter
Element".
2. Remove the pre-filter from the main filter.
PC-LR3076_IM

Child Lock

Press the LOCK button to enable or disable the child lock.
This prevents the operation of the appliance.

Ionizing Function

The electronic ionization of the air causes dust particles to
become electrostatically charged. As a result, they combine
to form larger particles and thus get caught by the HEPA
filter in a more reliable manner.
• The ionization function can only be switched on and
• When the ionization function is activated, the "IONS"

Cleaning / Maintenance

3. If required, you may gently clean the pre-filter and the
4. Then reattach the pre-filter to the main filter.

Replacing the Filter Element

In case the airflow at the outlet decreases during operation,
the filter element must be replaced.
1. Remove the cover located at the back of the appliance.
2. Remove the filter element.
3. If dust has accumulated on the grille located in front of
4. Insert the new filter element.
5. Replace the cover.
NOTE:
off via the ION button on the remote control. This is not
possible on the appliance.
control lamp lights up.
main filter by beating it or carefully wiping it with a soft
brush or a damp cloth.
CAUTION:
Do not immerse the filter element in water!
the fan, you may use a brush for removal.
41
28.11.19