Personal Safety; Roll Groover Safety - Ega Master 56066 Manual De Instrucciones

• Use only three-wire extension cords which have three-prong grounding plugs and three-pole re-
ceptacles which accept the tool's plug. Use of other extension cords will not ground the tool and
increase the risk of electrical shock.
• Keep all electric connections dry and off the ground. Do not touch plugs or tool with wet hands. Re-
duces the risk of electrical shock.
• Stay alert, watch what you are doing and use common sense when operating a power tool. Do not
use tool while tired or under the influence of drugs, alcohol, or medications. A moment of inattention
while operating power tools may result in serious personal injury.
• Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your hair, clothing,
and gloves away from moving parts. Loose clothes, jewelry, or long hair can be caught in moving
parts.
• Avoid accidental starting. Be sure switch is OFF before plugging in. Carrying tools with your finger
on the switch or plugging in tools that have the switch ON invites accidents
• Use safety equipment. Always wear eye protection. Dust mask, non-skid safety shoes, hard hat, or
hearing protection must be used for appropriate conditions.
• Roll Groover is made to groove pipe and tubing. Follow instructions in Operator's Manual on ma-
chine uses. Other uses may increase the risk of injury.
• Keep hands away from grooving rolls. Do not wear loose fitting gloves when operating unit. Fingers
could get caught between grooving and drive rolls.
• Keep guards in place. Do not operate the groover with guard removed. Exposure to grooving rolls
may result in entanglement and serious injury.
• Set-up Groover on a flat, level surface. Be sure the machine, stand, and groover are stable. Will
prevent tipping of the unit.
• Do not wear loose clothing. Keep sleeves and jackets buttoned. Do not reach across the machine
or pipe. Clothing can be caught by the pipe resulting in entanglement and serious injury.
• Do not use this Roll Groover with a Power Drive or Threading Machine that does not have a foot
switch. Foot switch is a safety device to prevent serious injury.
• When grooving pipe, keep hands away from the end of the pipe. Do not reach inside pipe end. Will
prevent being cut on sharp edges and burrs.
• Be sure groover is properly secured to the power drive or threading machine. Carefully follow the
setup procedures. Will prevent tipping of the pipe or grooving unit.
• Properly support pipe with pipe stands.
• Use only power drives and threading machines that operate under 58 RPM. Higher speed machi-
nes increase the risk of injury.

PERSONAL SAFETY

ROLL GROOVER SAFETY

15