Starting Engine - Zenoah RedMax EDG2300R Manual De Instrucciones

Perforadora portátil a gasolina
Tabla de contenido

Publicidad

OP1
.04 or .08 in.
(1~2mm)
OP2
OP3
(3)
OP4
26
(1)
(2)
(3)
(1)
(A)
(B)
(2)
English
7. Operation
■ THROTTLE CABLE ADJUSTMENT
Check the throttle cable play and adjust to .04 or .08 in.
(1~2mm) at the carburetor side.
(1) Throttle cable
(2) Adjusting screw
(3) Lock nut

■ STARTING ENGINE

1. Set ignition switch to "RUN" position. (OP2)
(1) Ignition switch
(A) RUN
(B) STOP
2. When first starting up after putting fuel into the
machine, or when re-starting after running out of
fuel, push the priming pump until fuel runs out the
overflow pipe. (OP3)
(1) Choke lever
(2) Overflow pipe
(3) Priming pump
(A) CLOSE
(B) OPEN
3. Close the choke (push the choke lever front ward).
4. While firmly holding the auger as illustrated,
vigorously pull the starter rope.
5. When engine has ignited first, open the choke (move
the choke lever backward), pull the starter rope
again and the engine will start.
WARNING
Keep the drill clear of everything around it as they
will start moving with the engine start.
6. Pull the throttle lever slightly, and it will be unlocked
automatically.
7. Allow the engine to warm up for a couple of minutes
before starting operation.
NOTE
• When re-starting immediately after stopping engine,
keep the choke open.
• If the engine won't start even after repeated
attempts, it may be overfed with fuel. Remove and
dry the spark plug, and try to start again with the
choke open.

Publicidad

Tabla de contenido
loading

Tabla de contenido