Swiss+go LYNX Manual De Instrucciones página 11

Operating
Normal Function
1. Rotate the VOLUME knob on the panel or press the key VOL+/- on the remote control to adjust the volume control to your
listening level.
2. Press the key MODE on the panel or on the remote control to select TUNER/AUX/USB/BLUETOOTH mode.
3. Press the PREV/NEXT key on the panel or the
4. Press the MUTE key on the remote control to mute, press it again to reset.
Light color control function
To control the light modes coming from the speaker panels by pressing the "light Mode" button on the left
side control panel. Each pressing will get below di erent colors.
Mode one: red lights ash
Mode Two: green lights
Mode Three: blue lights ash
Mode Four: "Auto", the various color combinations cycle through and ash.
Mode Five: "OFF", turn o the light
Notes:
1. The brightness of the light will change as the audio signal intensity.
2. The light will turn o automatically when no audio signal input.
Tuner application
1. Adjust the antenna to obtain optimum reception.
2. Press MODE key on the panel or on the remote control, to select TUNER function, frequency is showed on the LED display.
3. Press or hold the TU- /TU+ keys on the panel you can adjust the radio frequency tune, short press to nd tune FM channel
and long press to select preset channel.
4. Press AUTO key on the front panel to auto search FM channel.
KARAOKE function
1. The machine can auto detect whether MIC1,MIC2 is inserted. Please turn o the microphone volume and adjust the volume
gradually after inserting the microphone.
2. Rotate MIC VOLUME knob to change t on the panel he microphone VOLUME.
3. Rotate ECHO key on the panel or press the MODE key on the remote control to display ECHO, then press +/- or rotate VOLUME
knob to change the microphone ECHO.
Note : Do not touch the top of the microphone when singing in order to avoid howling e ect.
Adjust the microphone volume gradually to avoid howling e ect .
Bluetooth Pair & Connection
• Turn o any Bluetooth devices previously paired (linked) with this unit.
• Turn on the Bluetooth features on your phone or music player.
• Turn on and set this unit in the Bluetooth mode.
• Set your phone or music players to search for Bluetooth devices.
• Select LYNX from search results on your phone or music player.
• Select OK or Yes to pair this unit with your phone or music player.
• If protected, enter 0000 for passkey. Steady BT light indicates successful connection.
• Long press the BLUETOOTH key on the front panel to disconnect previous device
and enter pairing mode.
Function of USB reader
This unit has a USB jacks. Press the MODE key to select USB,then you can insert a USB to play music.
Important:
The USB port is intended only for data transfer only, other devices cannot be used with this USB connection.
The use of USB extension cords is not recommended.
/ key on the remote control to select previous or next song.
English