Troubleshooting - Remington RM2599 Manual Del Operador

Ocultar thumbs Ver también para RM2599:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PROBLEM
THE ENGINE WILL NOT START
The fuel tank is empty
The primer bulb was not pressed enough
The engine is flooded
The fuel is old (over 30 days) and/or improperly mixed
The spark plug is fouled
THE ENGINE WILL NOT IDLE
The air filter is dirty
The fuel is old (over 30 days) and/or improperly mixed
The idle speed is incorrect
THE ENGINE WILL NOT ACCELERATE
The fuel is old (over 30 days) and/or improperly mixed
The air filter is dirty
THE ENGINE LACKS POWER OR STALLS
The fuel is old (over 30 days) and/or improperly mixed
The air filter is dirty
The spark plug is fouled
THE GUIDE BAR AND SAW CHAIN ARE RUNNING HOT, SMOKING OR STUCK
The saw chain tension is too tight
The chain oil reservoir is empty
THE SAW CHAIN DOES NOT ROTATE
The saw chain tension is too tight
The guide bar and saw chain are assembled incorrectly
The guide bar and saw chain are damaged
The drive assembly is damaged
THE SAW CHAIN ROTATES, BUT DOES NOT CUT
The saw chain is dull
The saw chain is on backwards

TROUBLESHOOTING

If further assistance is required, contact an authorized service dealer.
SOLUTION
Fill the fuel tank with properly mixed fuel
Press the primer bulb 10 times or until fuel is visible
Move the choke lever to Position 3, press the throttle lockout,
squeeze the throttle control and pull the starter rope
Drain the fuel tank and add fresh, properly mixed fuel
Replace the spark plug
Clean or replace the air filter
Drain the fuel tank and add fresh, properly mixed fuel
Adjust the idle speed
Drain the fuel tank and add fresh, properly mixed fuel
Clean or replace the air filter
Drain the fuel tank and add fresh, properly mixed fuel
Clean or replace the air filter
Replace the spark plug
Adjust the saw chain tension
Refill the chain oil reservoir
Adjust the saw chain tension
Refer to Installing / Replacing the Saw Chain
Inspect the guide bar and saw chain for damage. Replace them if
necessary
Refer to Service information
Replace the saw chain or have it sharpened by an authorized
service dealer
Check and correct the saw chain direction
19

Publicidad

Tabla de contenido
loading

Tabla de contenido