Unit Diagram; Door Handle Installation (Not Applicable For All Models); Door Swing Reversal (Optional) - Impecca RA-2138 Manual De Usuario

UNIT DIAGRAM

1. Separate Freezer Section
2. Glass Shelf
3. Fresh Room
4. Refrigerator Air Duct
5. Glass Shelf
6. Temperature Controller
7. Vegetable Box Cover
8. Vegetable Box
9. Leg Front (left)
10. Gasket Freezer
11. Door Freezer
12. Freezer Rack
13. Refrigerator Rack
14. Refrigerator Door
15. Bottle Rack
16. Gasket Refrigerator
17. Leg Front (right)
DOOR HANDLE INSTALLATION (NOT
APPLICABLE FOR ALL MODELS)
The refrigerator must be disconnected before attempting the
installation of door handles.
Step 1: Install the two Phillips head screws into the door holes
and turn screws until fully in place.
Step 2: Position the door handle on the screws installed in
Step 1.
Step 3: Install screws at the hole located on the side of the
handle and turn screws until completely tight. Install
screw caps as shown in the figure above.

DOOR SWING REVERSAL (OPTIONAL)

It is advised that you determine if you need to reverse the door
swing and complete this procedure prior to installing
and turning on your refrigerator.
Note: These instructions are for changing the hinges from the
right side to the left side. If you wish to change the hinges back
to the right side, follow these same instructions and reverse all
references to left and right.
CAUTION:
To avoid injury to yourself and/or property, we recommend
someone assist you during the door reversal process.
• Ensure the appliance is unplugged and empty.
• Adjust the two leveling feet to their highest position.
• Have something solid against which to rest the appliance.
This will be necessary when it comes to taking off the door
• Avoid laying the refrigerator completely flat on its back as
this may damage the cooling system.
TOOLS REQUIRED:
• Phillips screwdriver
• Allen Key
• Flathead screwdriver
STEP 1: REMOVE THE FREEZER DOOR
Using a flathead screwdriver, gently pry and lift the right top
hinge cover and the left cover plate. Using a Phillip's screw-
driver, unscrew the screws of the right top hinge. Remove the
upper hinge. Raise the freezer door upward to detach.
Le cover plate
–5–
Right top
hinge cover