Custom Settings; Adjusting The Meter Display; Directional Key Use And Operation / Navigating The Meter Map; Using The Meter Display To Program Charging Set-Points And Load Control - Morningstar Essential Serie Manual Del Operador

The green, yellow or red LED will light depending on
the battery state-of-charge (SOC). Confirm that one of
these LEDs is on before going to the next step.
Close the solar disconnect. If the solar input is
connected while in sunlight, the charging LED
indicator will light. Confirm proper connection by
observing the charging LED.
Insert the load fuse, or close the breaker, and turn the
load on to confirm a proper connection.
STEP 8: To Power-Down
WARNING: Risk of Damage.
ONLY disconnect the battery from the EcoPulse
AFTER the solar input has been disconnected.
Damage to the controller may result if the battery
is removed while the EcoPulse is charging.
• To prevent damage, power-down must be done in
the reverse order as power-up.
18
Installation

3.5 Custom Settings

3.5.1 Adjusting the Meter Display

The display setting options are adjustable by using
the directional keys to locate and edit a desired
display setting.
3.5.2 Directional Key Use and Operation / Navigating
the Meter Map
A lit key indicates a valid direction in the meter
map. The current location is indicated on the
display with a column heading, and a bold descriptor.
3.5.3 Using the Meter Display to Program Charging
Set-points and Load Control
From the top level monitoring screens, scroll down
to the Main Menu - "Custom Programming" - screen.
Select the desired category, and edit the variable or
setting as instructed in the meter display.
Only metered models are capable of custom
programming. MSView (Morningstar's programming
software) is not compatible with the EcoPulse product.
EcoPulse Operator's Manual 19