Section 8. Display Readings; Display Readings And Descriptions - Jandy Pro Series TruClear Manual De Instalación Y Operación

Page 26
ENGLISH

Section 8. Display Readings

8.1 Display Reasons and Descriptions
Display Reading
EN
English
Standby
Chlorinating
Cleaning
Lo Temp/Lo Salt
No Flow
Check Cell
Check Cell
Over Temp
Jandy Pro Series TruClear
®
Reason
Language on startup
Language
Standby
Chlorination
Polarity is reversing
Low water conductivity
No flow or low flow
Cell overload
Cell open circuit
Overheated controller
|
Chlorine Generating System
™
Description
This is the acronym which should appear
during the 3 seconds startup screen.
Language selected/available for the user.
Output is OFF while selection is made.
When the system is ready and waiting for
the next valid chlorination cycle without any
errors. Output is OFF.
When the system is operating within a valid
chlorination cycle without any errors. Output
is ON.
When the system is operating within valid
chlorination cycle and the duty cycle timer
has expired. Output is OFF.
When the system detects low water
conductivity, this could be caused by cold
water, low salt levels, or a combination of the
two. Check the salt level. Output is ON.
When the system detects an absence of flow
while operating within a valid chlorination
cycle. Output is OFF.
When the system is running within a valid
chlorination window and detects a cell short
circuit or overload. Designed to warn the
user or service person. Output is OFF.
When the system is running within a valid
chlorination window and detects a cell open circuit
or disconnection. Designed to warn the user or
service person. Output is off but retries each 30
seconds.
The controller detects internal temperature and
may can reduce output power as a self-protection
feature.
At 70ºC (internal) output power to the cell is
reduced by 50% (no message displayed).
At 80º C (internal) output power to the cell is
reduced to 0% (OFF), and this over temperature
error is displayed. Output is OFF.
Designed to warn the user or service person of
overheating.
Please confirm that this warning message
automatically disappears when internal temp goes
below 80 °C.
Installation & Operation Manual