Program The Supplied Remote Control - RCA DTA800B1 Manual De Usario

Setting up (continue)
4. The Channel List is displayed once scanning is nished.
Press or to select channel and OK to start viewing.
Channel List
Channel What's on Now
2-1 KTVU Stored Current program Next program
2-2 KTVU Stored Current program Next program
4-1 KRON Stored Current program Next program
• You may also hide unwanted channels,
refer to "Channel List" on page 8 for
details.

Program the supplied remote control

You can control TV sets of all major brands
after programming the Converter Box
remote control with the PGM key. RCA
TV sets can be controlled directly without
programming. Refer to the steps below and
the separate Program Code lea et to guide
you through the programming.
1. Refer to the Program Code at the last page
of this booklet. Look for the brand of your
TV set and a 3-digit program code next to
it. There may be more than one program
code available. Choose any one of them.
Program codes/Códigos de programa
Admiral 002, 128, 183, 189
Advent 191, 258, 260, 275
Adventura 129
2. Press PGM on the remote control. The
signal indicator on it remains lit.
6
What's on Next
signal
indicator
Your Converter Box is now ready for use!
Tip:
To continue to view non-digital TV broadcasts,
if available, press the BOX
__________
Converter Box in stand-by mode (amber light), then switch
your TV to channel 3 or 4 (depending on which channel the
Converter 's CH3/CH4 selector switch is set to).
You must have the RF coaxial cable connected to your
TV input, in order to watch non-digital TV broadcasts.
3. Enter the 3-digit program code with the
number keys. Press OK
The signal indicator will be o when the
program is done.
4. Press the volume keys on this
remote control to check if
they can adjust the volume
of your TV set.
• If you fail to control your TV set,
repeat steps 2 to 4 to program again. Try
another program code if there is more
than one for your TV brand.
• If the signal indicator remains lit after
blinking four times, you may have
entered the wrong code. Repeat steps 3
to 4 to program again. Make sure you
have correctly entered the code.
• You can still use your TV remote control
to turn on your TV set, select input
source and control the volume.
on your remote to place the
for con rmation.
DTA800B1_IB_EN_E_V3