iMPORTANT NOTES TO
THE iNSTALLER
iMPORTANT
SAFETY
iNSTRUCTiONS
,
,
Read all instructions
contained
in these installation
instructions before installing the Microwave Wall Oven.
This oven can be built into a cabinet or wall by itself or
above any electric wall oven or warming drawer.
Remove all packing material from inside the oven cavity
before connecting the electrical supply to the Microwave
Wall Oven. DO NOT REMOVE THE WAVEGUIDE COVER,
which is located on the cavity ceiling. See Figure 2A.
Waveguide Cover
Oven Cavity
Door Seals
and Sealing
Surfaces
Hinge
Safety
Door Latch
ventilation can be dangerous.
Carpentry
Refer to Figure 1 for the dimensions
required for your
appliance, and the space necessary to install the oven. The
oven support surface should be solid plywood or similar
material, the surface must be level from side to side and
from front to rear.
Electrical
Requirements
The appliance
operates on a 120 volt, 60 Hz electrical
supply with a separate ground wire.
Provide a separate
circuit with a fuse or circuit breaker rated for 15 amps.
Observe
all governing
codes and local
ordinances
,
,
Figure 2A
Figure 2B
Remove the 2 shipping duct supports (see Figure 2B) by
removing the 2 screws securing each side. Reinsert 2
screws (each side) to secure the stainless cover.
Remove the feature sticker, if there is one, from the
outside of the door.
T0p"event damage to the oven contio!: duiing _old
ternperature weather, wait at least three (3)hours
after receiying this oven before supplyieg power to
the
appliance. This will prevent possible damage to the
buiBin oven control at power on.
,
Check the oven for any damage, such as misaligned or
bent door, damaged door seals and sealling surfaces,
broken or loose door hinges and latches and dent
inside the cavity or on the door.
AUTHORIZED SERVICER
6. Observe all governing codes and local ordinances.
7. Be sure to leave these instructions with the consumer.
iMPORTANT
NOTE TO
THE CONSUMER
Keep these instructions with your Owner's Guide for future
reference.
Cabinet
Installation
The Mkrowave
Wall
oven
can tip when
the door
is openl
The Anti-Tip
brackets
supplied
with
th e
Microwave
Wall
Oven
must
be attached
to the
cabinet
and the
appliance
t0 prevent
tipping
of
the unit and injury
to persons;
,
ANTI41P BRACKETS INSTALLATION
INSTRUCTIONS
Unpack the Microwave
Wall Oven and find the 2
Anti-Tip brackets and screws included in the literature
package.
Install the Anti-Tip bracket in the cabinet as shown
on Figure 3. Note: To prevent damage to cabinet, it
is recommended
to drill 1/16"(0.16 cm) diameter pilot
holes before installing the Anti-Tip brackets.
E2