EN
1
DESCRIPTION
1.1
PURPOSE
This machine is used for domestic lawn mowing. The
cutting blade must be approximately parallel to the
ground. All four wheels must touch the ground while you
mow.
1.2
OVERVIEW
Figure 1 - 12
Handle knob
1
Lower handle
2
Bracket
3
Upper handle
4
Bolt
5
Knob
6
Grass catcher
7
Mulch plug
8
Rear discharge door
9
Grass catcher handle
10
Hook
11
Slot
12
Mulch plug handle
13
Discharge chute
14
Height adjustment lever
15
Battery door
16
Battery compartment
17
Safety key
18
Battery release button
19
Start button
20
Handle bar
21
Bail switch
22
Self-propel lever
23
Speed control button
24
Blade
25
Wood
26
Mounting screw
27
Key cover
28
Spacer
29
Post
30
Tab
31
Storage switch
32
2
SAFETY
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
WARNING
English
3
INSTALLATION
Do not change or make accessories that are not
recommended by the manufacturer.
Do not put in the safety key or the battery pack until
you assemble all the parts.
3.1
UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
•
If the parts have damage, do not use the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
3.2
UNFOLD THE LOWER HANDLE
Figure 2.
1. Pull and turn the handle knobs 90°.
2. Unfold the lower handle.
3. Line up the handle knobs in one of the three
positions on the brackets.
4. Turn the handle knobs 90° until they engage the
holes in the brackets.
Make sure that the two handle knobs are in the same
position.
Do not make damage to the cables when you fold or
unfold the handle.
3.3
INSTALL THE UPPER HANDLE
Figure 3.
4
WARNING
WARNING
WARNING
WARNING
NOTE
WARNING