Automatic Boost Function; Operate The Self-Propel System; Empty The Grass Catcher; Operate On Slopes - Powerworks PD60LM61SP Manual Del Operario

EN
4.3

AUTOMATIC BOOST FUNCTION

When the machine cuts high grass the rpm is
automatically increased in order to keep a good cutting
and collecting results.
When the machine goes back to usual cutting
conditions the rpm automatically goes back to the
standard rpm to keep work time.
4.4 OPERATE THE SELF-PROPEL
SYSTEM
Figure 8.
1. Start the machine.
2. While you hold the bail switch, push the self-propel
lever in the direction of the handle bar.
3. Hold the bail switch and the self-propel lever at the
same time with your right hand.
4. Adjust the speed control button with your left hand.
• Push the speed control button in the direction of
the Rabbit Symbol to increase the speed.
• Pull the speed control button in the direction of
the Turtle Symbol to decrease the speed.
5. Release the self-propel lever to close the self-propel
system.
4.5

EMPTY THE GRASS CATCHER

Figure 9.
1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge door and hold it.
5. Hold the grass catcher by its handle and unhook it
from the slots.
6. Close the rear discharge door.
7. Empty the grass catcher.
4.6

OPERATE ON SLOPES

Do not mow on the slopes with decline more than 15°.
If you are not comfortable, do not mow on a slope.
Please keep a low self-propelled speed when you
mow on a slope.
• Do not go up and down on a slope when you mow
across the face of the slope. Be careful when you
change the direction on a slope.
WARNING
WARNING
English
• Monitor the holes, ruts, rocks, and other hidden
objects that can cause you to fall. Remove all
obstacles such as rocks and tree limbs.
• Make sure that your footing is stable. If you are out
of balance, release the bail switch immediately.
• Do not mow near drop-offs, ditches, or
embankments.
4.7

OPERATION TIPS

• Do not try to override the operation of the start
button or bail switch.
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning
parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick
grass.
• Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other
debris.
5

MAINTENANCE

Remove the safety key and battery pack from the
machine before maintenance.
Keep the engine and battery pack free from grass,
leaves or too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
5.1

GENERAL MAINTENANCE

• Before each use, examine the machine for
damaged, missing, or loose parts such as screws,
nuts, bolts and caps.
• Tighten correctly all the fasteners and caps.
• Clean the machine with a dry cloth. Do not use
water.
6
WARNING
WARNING
CAUTION
CAUTION
CAUTION