Wear Parts - Fiap AIR ACTIVE OxyFlow Instrucciones De Uso

GB
flow rate is reduced (e.g. hose diameter too small, ball valve in the line, delivery height too
high, contamination, etc.) the operating temperature rises significantly. From 55 degrees
Celsius, more lime is deposited on the pump motor. In the worst case, this layer of lime-
scale becomes so thick that the rotor runs very stiffly, blocks and the motor burns out.
Damage caused by soiling and calcification is excluded from the guarantee. The user has
to maintain and clean the pump properly depending on the amount of dirt and limescale.
Observe the relevant product videos on the subject of
cleaning and maintenance
n our Youtube channel:
https://www.youtube.com/user/FIAPGmbH

WEAR PARTS

The pump may only be used in water when it is submerged. The pump must not run
dry. The dry run leads to rapid wear and tear and damages the pump in the long term.
Use in polluted water with solids and particles also leads to premature wear and has a
negative impact on the service life of the pump. Algae or others plants that wrap around
the filter basket and can quickly clog it lead to reduced water flow and increased wear.
We recommend operating the device exclusively in bodies of water without plants, or to
ensure that no plants can be sucked in. Wear parts are excluded from the guarantee.
Appropriate cleaning and care reduce wear and tear on the device.
REPAIR
The power supply unit and the LED lighting cannot be repaired if the cables or the hou-
sing are damaged and must therefore be replaced. If you have any questions or problems,
please contact a qualified electrician or your specialist dealer for your own safety.
STORAGE
If frost is expected, the device must be taken out of service and dismantled. First clean
the device as described under Cleaning and Maintenance. The device can be stored dry
or wet. If the device is to be stored dry, it is important that all components, including
the internal engine parts, are completely dry. Set when stored wet
Place the cleaned aerator in a container filled with fresh tap water.
Make sure that the container is set up frost-free.
DISPOSAL
The device must be disposed of in accordance with national legal regulations. This device
must not be disposed of as domestic waste. Make the device unusable by cutting the
cable and dispose of it via the return system provided.
If the device contains light sources, they must be disposed of using the return system
provided for this purpose.
Ask your specialist dealer.
POND AERATION
1 1