Stanley BARFLEX BF0109 Manual De Instruccion página 4

BF0109_ManualENSP_061809.qxp
Adjusting the pivot tube
The pivot tube allows the BarFlex™ to be tilted backward and forward to direct the illumination upward or
downward.
CAUTION: TO REDUCE THE RISK OF PRODUCT DAMAGE:
• Do not attempt to "force"the pivot tube beyond its maximum angle.
• The pivot tube was designed to tilt forward and backward only.
• The pivot tube was designed to be used when the unit is hanging or attached to a surface using its magnetic
base. Using it when the unit is placed on a level, non-metallic surface may cause the BarFlex™ to fall over and
sustain damage.
• NEVER attempt to rotate the light tube itself. Always use the pivot tube to adjust the area of illumination.
Using the carabineer hanging hook and magnetic base
The hanging hook and magnetic base allow you to position the BarFlex™ for convenient, hands-free operation. The
hanging hook rotates 360° to direct illumination as needed.
CAUTION: TO REDUCE THE RISK OF PRODUCT DAMAGE:
• When the hanging hook is in use or the light is attached using the magnetic base, do not shake the light.
• When light is hung by the hanging hook or attached using the magnetic base, do not shake the light or object
that it is hanging from or attached to. Do not hang the light from or attach the light to any electrical wires or
anything that it is not secure.
• Only use the hanging hook for hanging the BarFlex™. The hanging hook is not intended to support additional
weight. Do not attach or hang anything additional to the light or risk of breakage may occur.
CARE AND MAINTENANCE
All batteries lose energy from self-discharge over time and more rapidly at higher temperatures. When the unit is
not in use, we recommend that the battery is charged at least every 120 days.
Never submerge the unit in water. If the unit gets dirty, gently clean the outer surfaces of the spotlight unit with a soft
cloth moistened with a mild solution of water and detergent.
There are no user-replaceable parts. Periodically inspect the condition of chargers. Contact manufacturer to replace
any components that have become worn or broken.
Battery replacement/disposal
BATTERY REPLACEMENT
The battery should last the service life of the unit. Contact manufacturer for any information you may need.
SAFE BATTERY DISPOSAL
This unit contains a nickel metal hydride rechargeable battery pack, which must be disposed
of properly when it will no longer retain a charge. For information on recycling this battery,
call toll-free (800) 822-8837.
To locate a free recycling program collection center near you, go to www.call2recycle.org.
6/18/2009 2:51 PM Page 6
6
WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting
(shorting can result in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.
TROUBLESHOOTING
Unit will not charge
1. Check connection to the 6 volt DC charging port.
2. Check connection to AC power source.
3. Confirm there is a functioning AC current.
Unit will not operate
1. The battery may be completely discharged. Charge the unit following the directions.
2. If the light does not operate after recharging as directed, contact manufacturer at (877) 571-2391.
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or authorized service center. If
you need assistance regarding accessories, please contact manufacturer at (877) 571-2391.
WARNING: The use of any accessory not recommended for use with this appliance could be hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement parts, contact the manufacturer at
(877) 571-2391.
ONE-YEAR LIMITED WARRANTY
Manufacturer warrants this product for one year against any defects in material or workmanship. The defective
product will be replaced or repaired at no charge in either of two ways.
The first, which will result in exchanges only, is to return the product to the retailer from whom it was purchased
(provided that the store is a participating retailer). Returns should be made within the time period of the retailer' s
policy for exchanges (usually 30 to 90 days after the sale). Proof of purchase may be required. Please check with
the retailer for their specific return policy regarding returns that are beyond the time set for exchanges. The second
option is to return the product (prepaid) to the manufacturer for repair or replacement at our option. Proof of
purchase may be required.
This warranty does not apply to accessories. This warranty gives you specific legal rights and you may have other
rights which vary from state to state or province to province. This product is not intended for commercial use.
7