Low Battery Indication - DeWalt DW074 Manual De Instrucciones

LOW BATTERY INDICATION

When the batteries approach end of life, the power LED indicator
light (H) will begin to flash. When this signal is observed, only a
short period of runtime is left before the unit will completely shut
down. The batteries should be replaced with new batteries as soon
as possible.
Using the Laser on a Tripod
1. Position the tripod securely and set it to the desired height.
2. Make sure that the top of the tripod is roughly level. The laser
will self-level only if the top of the tripod is within ± 5˚ of level. If
the laser is set up too far out of level, it will beep when it reaches
the limit of its leveling range. No damage will be done to the
laser, but it will not operate in an "out of level" condition.
3. Secure the laser to the tripod by screwing the threaded knob on
the tripod into the female thread on the bottom of the laser.
NOTE: Be sure that the tripod you are working with has a
5/8"–11 threaded screw to ensure secure mounting.
4. Turn the laser on and adjust the rotation speed and controls as
desired.
FIG. 4
PLUMB
MODE
LEVEL
MODE
6
Using the Laser on a Floor (Fig. 4)
The laser level can be positioned directly on the floor for leveling
and plumbing applications such as framing walls.
1. Place the laser on a relatively smooth and level surface where
it will not be disturbed.
2. Position the laser for a level or plumb setting as shown.
3. Turn the laser on and adjust the rotation speed and controls as
desired.
NOTE: The laser will be easier to set up for wall applications if the
rotation speed is set to 0 rpms and if the remote control is used to
line up the laser with control marks. The remote allows one person
to set up the laser.
Manual Head Rotation
The laser is designed with a protective roll cage around the rotary
head to prevent accidental damage from work site activities. You
can still access the rotary head and manually direct the beam to
establish or transfer a mark.
Laser Accessories
Recommended accessories for use with your tool are available for
purchase at your factory-owned local service center.
WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk
of injury, only D WALT, recommended accessories should be used
E
with this product.
If you need assistance in locating any accessory, please contact
D WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
E
21286, call 1-800-4-D WALT (1-800-433-9258) or visit our website
E
www.dewalt.com.