Assembly; Unpackpressurewasher; Attach Handle, Cleaning Tank And Accessory Tray - Troy-Bilt 020344-2 Manual Del Operario

Assembly
Read entire operator's manual beforeyou attempt
to assemble or operateyour new pressurewasher.
Your pressure washer requires some assembly and is ready
for use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your pressure
washer, pleasecall the pressure washer helpline at
(888} 611-6708. If calling for assistance, please havethe
model, revision, and serial number from the identification
label available.
UnpackPressureWasher
1. Remove the parts bag, accessories, and inserts
included with pressure washer.
2. Open carton completely by cutting each corner from
top to bottom.
3. Ensureyou have all included items prior to assembly.
Items in the cartoninclude:
• Main Unit
• Handle
• CleaningTank
• High Pressure Hose
• Spray Gun
• NozzleExtension with Quick Connect Fitting
• Plastic Accessory Tray
• Spray Gun Holder Wireform
• Oil Bottle
• Engine Operator's Manual
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Bag containing 4 Multi-Colored Spray Tips
• HandleFasteningHardwareKit (which includes):
• Carriage Bolts (2)
• Plastic Knobs (3)
• Tree Clips (6)
To prepare your pressurewasher for operation, you will
need to perform these tasks:
1. Fill out and send in registration card.
2. Attach handle, cleaning tank and accessory tray to main
unit.
3. Connect detergent siphon hose to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect high pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Select/attach quick connect spray tip to nozzle
extension.
Attach Handle, Cleaning Tank and Accessory Tray
1. Place handle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with
holes (C) on handle supports.
NOTE:It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Place cleaning tank (D) over holes (E) on handle
(viewing from rear of unit). Pushtree clips (F) into top
holes until they sit flat against cleaning tank.
I
NOTE:Make sure detergent shut-off valve and detergent
siphoning tube is facing down when installing cleaning tank.
3. Insert carriage bolts (G) through bottom holes of the
handle, handle supports and cleaning tank from front of
unit and attach a plastic knob (H) from rear of unit.
Tighten by hand.
%
4. Place accessory tray (J) over holes (K) on handle
(viewing from front of unit). Push the tree clips (L) into
the holes until they sit flat against the accessory tray.