Temperature & Duration Chart; Operating Battery Pack Settings; Battery Pack Led Lights (Leds); Using Heat Settings - Hotronic FootWarmer Power Plus m3 Manual De Usuario

Approx. Avg. Temp. Range
Set. °C
1 28°-32°
2 36°-41°
3 40°-47°
4 57°-62°
1. To turn on or off, press-and-hold ON or OFF until LED light is ON
or OFF (~2.0 seconds).
2. To change setting, press-and-hold ◄ or ► until setting LED light
changes (~0.5 seconds).
3. Once selected, setting 4 auto-resets to setting 3 after 3 minutes
("timed setting 4"). ("Timed setting 4" LED lights are ON
continuously and do NOT blink.)
4. To use "continuous setting 4", start at "timed setting 4", then press
and hold ► until all LED lights blink (~5.0 seconds). ("Continuous
setting 4" LED lights BLINK continuously until setting is changed.)
5. DO NOT USE "TIMED SETTING 4" or "CONTINUOUS SETTING
4" for more than three minutes at a time as it may become too hot
and may result in burns. SEE CAUTIONS REGARDING BURNS.
1. Battery Pack LEDs indicate power is on or off and setting selected.
LEDs do not indicate charge level.
2. LEDs will not light when batteries are fully discharged, are below
minimum voltage cutoff level, or do not have enough power to heat
Element.
3. WHEN BATTERY PACK LED stays ON and CANNOT BE TURNED
OFF, water may be around electrical contacts, may cause Heating
Element to become hot at any setting, and MAY RESULT IN BURNS.
See CAUTIONS REGARDING BURNS.
1. Use FootWarmer to maintain comfort and warmth. (Note: Prevent
feet from getting cold. Warming cold feet requires more energy, is
less effective, and is not intended use of FootWarmer.)
2. Before going into cold, set at 1, 2, or 3 to maintain comfort and
warmth.
3. For additional burst of heat, set to "timed setting 4". "Timed setting
4" auto-resets to setting 3 after 3 minutes.
4. DO NOT USE "TIMED SETTING 4" or "CONTINUOUS SETTING
4" for more than three minutes at a time as it may become too hot
and may result in burns. SEE CAUTIONS REGARDING BURNS.
5. Heat does not thermostatically cycle on and off. Settings 1 and 2
maintain warmth AND save energy.
1. Expect imperceptible heat to maintain comfort and warmth.
2. Do not expect "fireplace toes".
3. Learn what personally works best over time.
4. Think of your FootWarmer as Thermo Active Insulation (TM). As
cold penetrates through insole, it draws heat off Element rather than
toes. Balanced heat is imperceptible yet maintains comfort and
warmth. Too much heat and feet feel excess heat. Too little heat and
feet feel cold penetrating through.
5. If feet are comfortable yet feel excess heat, turn to lower setting to
minimize perspiration and maximize battery duration.
6. If feet begin to feel cool, turn setting up to maintain comfort and
warmth.
7. If you think FootWarmer is not working, try turning left Battery Pack
off. If left foot becomes colder, FootWarmer is working.
TEMPERATURE & DURATION CHART
°F
83°-89°
96°-106°
105°-116°
135°-144°

OPERATING BATTERY PACK SETTINGS

BATTERY PACK LED LIGHTS (LEDs)

USING HEAT SETTINGS

WHAT TO EXPECT OF HEAT SETTINGS

Duration Range
Power Plus
m4
19-21 hrs
7-9 hrs
5-6.5 hrs
2.5-3.75 hrs
- 7 -
Power Plus
m3
15-17 hrs
5.5-7 hrs
3.5-5 hrs
2-3 hrs