Vyaire MicroLab Manual De Funcionamiento página 43

36-CAB1121
36-CAB1057
36-CAB1051
36-CAB1060
The MicroLab has an essential performance – the product should continue
to operate correctly. In the unlikely event of a Fast Transient / ESD event
occuring, the device should be reset and located away from the source of
interference.
WARNING
: The MicroLab should not be used adjacent to or stacked
with other equipment. If adjacent or stacked use with other equipment is
necessary, the MicroLab and the other equipment should be observed /
monitored, to verify normal operation in the configuration in which it will
be used.
Guidance and Manufacturer's Declaration – Electromagnetic Emissions
The MicroLab is intended for use in the electromagnetic environment specified below.
The customer or the user of the MicroLab should assure that it is used in such an
environment.
Emission Test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC61000-3-2
Voltage fluctuations/
flicker emissions
IEC61000-3-3
Power line Brazil to mains adapter
Power line UK to mains adapter
Power line AUS/NZ to mains adapter
Power line US to mains adapter
Compliance
Group 1
Group B
Class A
Complies
Electromagnetic Enviroment -Guidance
The MicroLab uses RF energy only for
its internal function. Therefore, its RF
emissions are very low and are not likely to
cause any interference in nearby electronic
equipment.
The MicroLab is suitable for use in all
establishments, including domestic
establishments and those directly connected
to the public low-voltage power supply
network that supplies buildings used for
domestic purposes
43