Sony HAP-S1 Guía De Referencia página 8

Specifications
Amplifier section
Reference Power Output
40 W + 40 W (4 ohms, 1 kHz, THD 10%)
Rated Power Output
35 W + 35 W (4 ohms, 1 kHz, THD 0.9%)
Speaker impedance match
4 ohms – 16 ohms
S/N ratio
100 dB (20 kHz LPF, A Network)
Frequency response
10 Hz - 100 kHz (+0 dB, –3 dB) (4 ohms, LINE IN)
Network section
Wired LAN
1000BASE-T/100BASE-TX/10BASE-T
Wireless LAN
Compatible standards
IEEE 802.11 b/g/n
Frequency band/channel
2.4 GHz band: channels 1-13
HDD section
Capacity
500 GB*
* Some portions of the capacity are used for data management.
Therefore, the capacity a user can use is less than 500 GB.
Supported playback format
DSD (DSF, DSDIFF), LPCM (WAV, AIFF), FLAC, ALAC, ATRAC Advanced
Lossless, ATRAC, MP3, AAC, WMA (2 channels)
Jack section
Input section
COAXIAL IN
Input impedance: 75 ohms
Supported playback format: LPCM 2ch
8
GB
OPTICAL IN
Supported playback format: LPCM 2ch
LINE IN 1, 2
Input sensitivity: 500 mV
Input impedance: 100 kilohms
Output section
Output jacks
LINE OUT
Output impedance: 2.2 kilohms
2 Hz - 80 kHz (–3 dB)
PHONES (headphone jack)
Stereo jack: 8 ohms or higher
EXT port
Type A USB, Hi-Speed USB, for connecting an external hard disk drive
General and others
Power requirements
AC 230 V 50/60 Hz
Power consumption
On: 85 W
During standby mode (when [Network Standby] is set to [Off]): 0.3 W
During standby mode (when [Network Standby] is set to [On] and a
wired LAN is used): 2.6 W
During standby mode (when [Network Standby] is set to [On] and a
wireless LAN is used): 2.8 W
Dimensions (approx.) (w/h/d)
265 mm × 88 mm × 304 mm
including projecting parts and controls
Mass (approx.)
5.8 kg
Supplied accessories
AC power cord (1)
Remote control (RM-ANU183) (1)
R03 (size-AAA) batteries (2)
LAN cable (1)
Quick Start Guide (1)
Reference Guide (this manual) (1)
Design and specifications are subject to change without notice.