Stihl BT 130 Manual De Instrucciones página 18

English
B
Stand the unit on the tip of the
N
auger.
Disengage the auger brake by
N
moving the activating lever to
position B. Your earth auger is now
ready for operation.
Make sure the carburetor is correctly
adjusted. The auger must not rotate
when the engine is idling.
Stopping the Engine
Move the slide control to STOP - 0.
N
At very low outside temperatures
When the engine starts, blip the
N
throttle trigger to disengage the
starting throttle position – the slide
16
control moves to the run position F
and the engine settles down to idling
speed.
Open the throttle slightly.
N
Warm up the engine for a short
N
period.
If engine does not start
If you did not move the choke knob
quickly enough to e after the engine
began to fire, the engine is flooded.
Set the choke knob to e and
N
Set the slide control, trigger lockout
N
and throttle trigger to the starting
throttle position.
Start the engine by pulling the
N
starter rope briskly – 10 to 20 pulls
may be necessary.
If the engine still does not start
Move the slide control to STOP - 0.
N
Remove the spark plug – see
N
"Spark Plug".
Dry the spark plug.
N
Crank the engine several times with
N
the starter to clear the combustion
chamber.
Refit the spark plug – see "Spark
N
Plug".
Move the slide control to START.
N
Set the choke knob to e – even if
N
the engine is cold.
Now start the engine.
N
Throttle cable adjustment
Check adjustment of throttle cable –
N
see chapter on "Adjusting the
Throttle Cable".
If fuel tank has been run completely dry
and then refueled
After refueling, press the manual
N
fuel pump bulb at least five times –
even if the bulb is filled with fuel.
Set the choke knob according to
N
engine temperature.
Now start the engine.
N
BT 130