Delta 50-786 Manual De Instrucciones página 9

Recolector de polvo de 1-1/2 h.p.
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ATTACH FRONT PANEL TO
BASE (FIg. 12–15)
1.
P lace 5/16" lock washer (K) on 5/16" x 3/4" (19 mm)
hex head bolt (L).
2.
Line up holes in front panel (N) with holes in base
plate (S), as shown in Figure 12.
NOTE: Be sure front panel is oriented as shown in
Figure 13.
3.
P lace hex head bolt and washer assembly through
holes in front panel (N) and base plate (S).
4.
From underneath the base secure front panel to
base using a 5/16" hex nut (Q).
5.
Repeat for other hole in front panel and base.
6.
T he front and side panels are shown correctly
assembled in Figure 15.
NOTE: FASTEN ALL HARDWARE HAND TIGHT ONLY AT
THIS POINT. Hardware will be tightened later in a certain
order.
ATTACH MOTOR/BLOWER
TO STAND (FIg. 16, 17)
1.
P lace motor/blower housing on top of stand. Align
holes (T) in the housing with holes (U) in the stand.
2.
P lace 5/16" lock washer (K) on 5/16" x 3/4" (19 mm)
hex head bolt (L).
3.
Insert this washer/bolt assembly up through holes
(U) in stand and insert bolt into the threaded holes
(T) of the motor/blower housing. Hand tighten only.
4.
Repeat for five remaining holes.
NOTE: FASTEN ALL HARDWARE HAND TIGHT ONLY AT
THIS POINT. Hardware will be tightened later in a certain
order.
FIg. 15
FIg. 13
FIg. 16
L
FIg. 17
9
N
K
L
S
FIg. 12
Q
FIg. 14
T
U
K

Publicidad

Tabla de contenido
loading

Tabla de contenido