Electrical Safety - Black and Decker SCUMBUSTER S410 Manual Del Usuario

E N G L I S H
Have any damaged or defective parts repaired
x
or replaced by an authorised repair agent.
Regularly check the charger plug for damage.
x
Replace the charger if the plug is damaged or
defective.
Never attempt to remove or replace any parts
x
other than those specified in this manual.
Battery
Never attempt to open the battery for any reason.
x
Do not expose to water.
x
Do not store in locations where the
x
temperature may exceed 40 °C.
Charge only at ambient temperatures between
x
4 °C and 40 °C.
Before charging, make sure that the tool is dry
x
and clean.
Do not attempt to charge damaged batteries.
x
When disposing of batteries, follow the
x
instructions given in the section
"Protecting the environment".
Do not incinerate the battery.
x
Under extreme conditions, battery leakage
x
may occur. When you notice liquid on the
battery, proceed as follows:
- Carefully wipe the liquid off using a cloth.
Avoid skin contact.
- In case of skin or eye contact, follow the
instructions below.
The battery fluid, a 25-30% solution of
potassium hydroxide, can be harmful.
In case of skin contact, immediately rinse
with water. Neutralise with a mild acid such
as lemon juice or vinegar. In case of eye
contact, rinse abundantly with clean water
for at least 10 minutes. Consult a physician.
Fire hazard! Avoid short-circuiting the
contacts of a detached battery. Always fit
the cap to protect the battery during
transport or storage.
Charger
Use your Black & Decker charger only to
x
charge batteries of the type supplied with your
tool. Other batteries could burst, causing
personal injury and damage.
6
Never attempt to charge non-rechargeable
x
batteries.
Do not expose the charger to water or high
x
humidity.
Do not open the charger.
x
Do not probe the charger.
x
Do not use an extension cord. Plug the charger
x
directly into a wall socket, away from water and
hot surfaces.
The charger is intended for indoor use
only.

ELECTRICAL SAFETY

Your charger has been designed for a specific
mains voltage. Always check that the mains voltage
corresponds to the voltage on the rating plate.
Your charger is double insulated in
accordance with EN 60335; therefore no
earth wire is required.
BEFORE FIRST USE (fig. C)
Before first use, the battery must be charged
for at least 12 hours.
Remove the battery cover (4) from the tool.
x
Charge the battery as described below.
x
USE
Charging the battery (fig. C)
Insert the jack plug (5) into the connector (6) as
x
shown (fig. C).
Plug in the charger. Switch on at the mains.
x
Leave the battery to charge for at least 12
x
hours.
Whilst charging, the charger may become warm.
This is normal and does not indicate a problem.
When the battery is fully charged, the power
consumption of the charger is negligible.
Important! Recharge the battery when the
performance of the appliance decreases. Do not
continue to use the appliance until the battery is
empty. After fully charging the battery, the average
effective usage time is approx. 30 minutes. It may
take several charging cycles before the battery
attains full capacity.