Sears Craftsman 917.377593 Manual Del Propietário Y Guía página 15

ENGINE
SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that the engine is running too fast
or too slow, take your lawn mower to an
authorized service center for repair and
adjustment.
CARBURETOR
Your carburetor has a non-adjustable fixed
main jet for mixture control If your engine
does not operate properly due to sus-
pected carburetor problems, take your
lawn mower to an authorized service
center for repair and/or adjustment,
IMPORTANT: Never tamper with the
engine governor, which is factory set for
proper engine spee& Overspeeding the
engine above the factory high speed
setting can be dangerous, if you think the
engine-governed high speed needs
adjusting, contact your nearest
AUTHORIZED service center, which has
prope_ 7_quipment and experience to make
any necessary adjustments.
Tubular frame
Sewn hem
Sewn
hem
Flip lid
Lower frame
Tubular frame
(Frames
must be
fully
seated)
TO ASSEMBLE GRASS CATCHER
• Insert leg of tubular frame through front
opening of grass catcher and thread
frame into sewn hem of bag.
NOTE: Keep bag hem gathered on the
straight leg of the tubular frame.
o When frame comes out the other end of
sew{_ hem, immediately wo_k the end of
frame down inside the bag as shown in
inset.
o Slide -_.ewnhem evenly around the
tubuf_._ frame until both ends of frame
are exposed out of the front opening.
• Assemble lower frame to tubular frame
as shown. Be sure handle is outside of
bag and frames are fully seated as
shown in inset.
o Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold
them in warm water f_c,r a few minutes, tf
bag gets wet, le_ it dr,_ before _sing.
o Clos_ the flip tid,. Flip lid must be closed
_kwhile operating lawn mower.
CAUTION: Do not run your lawn
mower without clipping deflector or
approved grass catcher in place. Never
attempt to operate the lawn mower with
the rear door remov_:: "_rpr,:_p_ed open_
Lower frame handle
\
!5