Mounting - Tripp-Lite APS Serie Manual Del Propietário

200711151 93-2751 120V APS OM.qxd

Mounting

WARNING! Mount your Inverter/Charger BEFORE DC battery and AC power
connection. Failure to follow these instructions may lead to personal injury
and/or damage to the Inverter/Charger and connected systems.
Tripp Lite manufactures a variety of different Inverter/Chargers with a variety of different mounting options for use in vehicular or non-vehicular
applications. Tripp Lite recommends permanent mounting of your Inverter/Charger in any of the configurations illustrated below. User must
supply mounting hardware and is responsible for determining if the hardware and mounting surface are suitable to support the weight of the
Inverter/Charger. Contact Tripp Lite if you require further assistance in mounting your Inverter/Charger.
Vehicular and Non-Vehicular Horizontal Mount
(612 models only)
Using the measurements from the diagram, install two user-
A
supplied ¼" (6 mm) fasteners into a rigid horizontal surface,
leaving the heads slightly raised.
back over the fasteners to engage the mounting slots molded on the
bottom of the Inverter/Charger cabinet.
user-supplied ¼" (6 mm) fasteners into the mounting feet
molded on the front of the Inverter/Charger cabinet.
C
11/29/2007 2:47 PM Page 9
Slide the Inverter/Charger
B
Install and tighten two
C
A
B
9A
Vehicular and Non-Vehicular Horizontal Mount
(All models except 612)
Using the measurements from the diagram, install two user-
A
supplied ¼" (6 mm) fasteners into a rigid surface, leaving the
heads slightly raised. Slide the Inverter/Charger forward over
B
the fasteners to engage the mounting feet molded on the front of
the Inverter/Charger cabinet.
supplied ¼" (6 mm) fasteners into the mounting feet molded on
the rear of the Inverter/Charger cabinet. The rear feet extend
beyond the unit's cabinet to provide for adequate ventilation
space behind the cooling fan(s); they should not be removed.
B
A
Note: APS model cabinets may have different front panel features, but all have identical mounting.
Install and tighten two user-
C
C